Оценок - 1, средний балл: 4
(
)
)
|
Фрагмент инструкции
You can still make or receive calls with the ringer in OFF position, however, you will not hear the incoming ring. RECEIVER VOLUME The RECEIVER VOLUME CONTROL switch, located on the bottom of the telephone, allowsyou to adjust the volume of the receiver earphone from LOW and HI. INSTALLATION To connect the telephone, connect the line cord from the back of the telephone to the wall jack. MAKING AND ANSWERING CALLS To get a dial tone or answer an incoming call, lift the handset. To hang up, either replace the handset or press the HANDSET CRADLE manually. FLASH Pressing FLASH sends the electronic equivalent of a switchhook signal. Use FLASH with special phone company services such as call waiting. IF THERE IS NO DIAL TONE 1) Make sure that all plugs are connected properly. Check the connections at the wall jack, the telephone cabinet and handset. 2) Try another modular jack within your home which you know to be working properly. IF CALLS CANNOT BE DIALED OR DIALS SLOWLY Check to make sure that the DIAL MODE switch is in the correct position for the type of service (TONE/PULSE) available in your area. IF THE TELEPHONE DOES NOT RING Check that RINGER CONTROL switch is not set to OFF. If there are several telephones connected to the same line, try disconnecting some of the other telephones. Having too many telephones connected to the same line can cause low ringer volume or poor sound quality during calls. CARE AND MAINTENANCE Avoid rough treatment to the telephone. Do not drop the handset and always place it gently back in the cradle. Clean only with slightly dampened cloth. Do not use detergent, wax, solvent, spray, alcohol or excessive water. IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions, should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 4. Do not place this product on an unstable cart, stand or table. The product may fall, causing serious damage to the product. 5. Slots and openings in the cabinet and back or bottom are provided for ventilation, to protect it from overheating, these openings must not be blocked or covered. The openings should never be blocked by placing the product on the bed, sofa, rug, or other similar surface. This product should never be placed near or over a radiator or heat register. This product should not be placed in a built-in installation. 6. Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product. 7. To reduce the risk of electric shock, do not disassemble this product. Take it to a qualified serviceman when some service or repair work is required. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect re-assembly can cause electric shock when the appliance is subsequently used. 8. Unplug this product from the wall outlet and refer servicing to qualified service personnel in the following cases: A. When the power supply cord or plug is damaged or frayed. B. If liquid has been spilled into the product. C. If the product has been exposed to rain or water. D. If the product does not operate normally by following the operating instructions. Adjust only those controls, that are covered by the operating Instructions because improper adjustment of other controls may result in damage and will often require extensive work by a qualify technician to restore the product to normal operation. E. If the product has been dropped or the cabinet has been damaged. F. If the product exhibits a distinct change in performance. 9. Do not allow anything to rest on the power cord. Do not locate this product where the cord will be abused by persons walking on it. 10. Do not use this product near water, for example , near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool. 11. Avoid using a telephone (other than a cordless type) during an electric storm. There may be a remote risk of electric shock from lighting. 12. Do not use the telephone to report a gas leak in the vicinity of the leak. 13. Use only the power cord and batteries indicated in this manual. Do not dispose of batteries in a fire. They may explode. Check with local codes for possible special disposal instructions. SAVE THESE INSTRUCTIONS PARTS INCLUDED Your new telephone includes the following items: 1 - Telephone handset1 - Handset coil cord 1 - Telephone body1 - 7 Feet line cord 1 - 15 Inches line cord 2 -Screws with wall archors 4 - Rubber spacer pads. 2 - Tapping screw1 - Template (See above picture and instructions) LINE CORD JACK RING...