Оценок - 5, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
All intercoms must be set to the same channel or the paging channel to be in Conference Mode. To put intercom in Conference Mode set Dipswitch #2 to UP position. Monitor Mode: Monitor Mode is used to monitor the noise in a specifi c room. Place the intercom in the room that is to be monitored and press the Monitor button until a tone is heard. For extended Monitor usage, consider using a plug-in transformer. Any other networked intercom can listen to that room. If a specifi c channel is selected for Monitor Mode then only other intercoms on that channel or on the paging channel can listen. Press the Talk button to exit Monitor Mode. A tone will be heard indicating Monitor Mode is no longer active. Voice Activation Mode (VOX): Voice Activation Mode (VOX) allows a call to be answered without pressing the Talk button. Once a call is heard on an intercom which has been set to VOX, a response can be given by speaking loudly into the intercom. There will be a slight delay when VOX is fi rst activated by a voice, but will continue to transmit audio until the speaking stops. To put intercom into VOX, place Dipswitch #1 to the UP position. While in VOX mode, a call may be initiated by pressing the TALK button. Volume UP Button Talk Button Learn Button Dipswitch #1 AC Adapter Dipswitch #2 Models NLS1, NLS2, NLS1C & NLS2C Wireless Portable Intercom - Extreme Range ® VOLUME MONITOR CHANNEL HOLD OFF ACTIVE TALK 13 2 4 MONITOR HOLD OFF 1 3 2 4 VOLUME TALK ACTIVE OPTIONAL 1 2 1 2 Channel Select Button Channel Lights Active Light Volume DOWN Button Monitor Button Speaker VOLUME MONITOR CHANNEL HOLD OFF ACTIVE TALK 13 2 4 VOLUME MONITOR CHANNEL HOLD OFF ACTIVE TALK 13 2 4 2 Assemble Intercom Step 1 Install 4 AA Alkaline batteries (not provided). Step 2 Adhere rubber pads to bottom. Repeat Steps 1 and 2 for any additional intercoms. Programming Intercom The intercom must be programmed to at least one other intercom to become a network or it can be programmed into an existing network. Create New Network Before programming, clear memory on all intercoms. Press the Learn button on the new intercom until a beep is heard. Within 10 seconds put the second intercom into Learn Mode (refer to the following table). Each intercom will emit a tone when entering programming mode. It may take up to 3-1/2 minutes for a secure network to be established. Repeat for any additional intercoms. Add to an Existing Network Press the Learn button on the new intercom until a beep is heard. Within 10 seconds put any networked intercom into Learn Mode (refer to table below). Each intercom will emit a tone when entering Programming Mode. It may take up to 3-1/2 minutes for a secure network to be established. Repeat for any additional intercoms. NOTE: Do not program new intercoms to each other before adding them to the network or they will form a separate network and the memory will need to be cleared. Press and release the Talk button to verify network is complete. MONITOR HOLD OFF 1 3 2 4 V...
Эта инструкция также подходит к моделям:Проводные телефоны - NLS1C (1.06 mb)
Проводные телефоны - NLS1 (1.06 mb)
Проводные телефоны - NLS2 (1.06 mb)