Оценок - 4, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
MIC GAIN/OFF/MAX — Turn clockwise until you hear a click to turn on the intercom. Turn towards MAX to increase the volume or towards OFF to decrease the volume. Turn to OFF until you hear a click to turn off the intercom. Left Side Jacks (L) — Connect up to two headsets to the L jacks for the persons sitting on the left side. "+/2146#06"# go to the box on that page with the o RRRRy— Warning + ....— Caution — Important ±"016'"±"# batteries. • If you do not use the intercom for an extended period of time, remove the batteries. the earpiece, it might cause a piercing sound. • Turn MIC GAIN/OFF/MAX off or to the lowest level before connecting or disconnecting the headset. Thank you for purchasing the RadioShack Race Scanner Intercom with Pit Crew Headsets. It enables up to four people to listen to a scanner and communicate at the same time. It comes with two headsets and a 3-foot cable to connect a scanner to the intercom. Additional headsets are available at your local RadioShack store. 24'2#4#6+10+056#..+0)"$#66'4+'5 The intercom uses four AA batteries. For the longest battery life, we recommend RadioShack alkaline batteries. ±y 1. Push the battery compartment cover back and slide it off to open. 2. Place four AA batteries in the battery holder as indicated by the polarity symbols (+ and –). 3. Slide the cover back in place until it snaps shut. %100'%6+0)"#"5%#00'4"#61"6*'"+06'4%1/ Connect one end of the supplied scanner cable to the scanner’s headphone jack and the other end to the intercom’s AUDIO IN jack. %100'%6+0)"*'#&5'65 Turn MIC GAIN/OFF/MAX off or to the lowest level. ±±±±y Connect a headset for the person(s) on the left to either of the left side jacks (L) and a headset for the person(s) on the right to either of the right side jacks (R). This allows them to hear each other’s voice through the corresponding earpiece of their headset. For example, a listener on the right side will hear the other person’s voice in the the left left earpiece. .+56'0+0)"5#('.; • • • 64#((+%"5#('6; areas. hazard. If an icon appears at the end of a paragraph, corresponding icon for pertinent information. °°°° — Hint ±±±± — Note• When you turn on the intercom, the green LED lights. If the LED turns red, replace the • Disconnect the headset if it not being used. Otherwise, if the microphone is placed near Right Side Jacks (R) — Connect up to two headsets to the R jacks for the persons sitting on the right side. AUDIO IN — Connect the supplied scanner cable to AUDIO IN and the other end of the cable to the scanner headphone jack to listen to a scanner. earpiece. The scanner will be heard in the right earpiece. The listener on the left will hear the other person’s voice in the right earpiece. The scanner will be heard in the To protect your hearing, follow these guidelines when you use headsets. oe ±±±±y Set the volume to the lowest setting before you begin listening. After you begin listening, adjust the volume to a comfortable level. Do not listen at extremely high volume levels. Extended high-volume listening can lead to permanent hearing loss. Once you set the volume, do not increase it. Over time, your ears adapt to the volume level, so a volume level that does not cause discomfort initially might still damage your hearing. Do not use a headset with your intercom when operating a motor vehicle or riding a bicycle in or near traffic. Doing so can create a traffic hazard and could be illegal in some If you use a headset with your intercom while riding a bicycle, be very careful. Do not listen to a continuous broadcast. Even though some headsets let you hear some outside sounds when listening at normal volume levels, they still can present a traffic © 2002 RadioShack Corporation. All Rights Reserved. RadioShack and RadioShack.com are trademarks used by RadioShack Corporation. 12'4#6+1M 1. Turn on your scanner and set its volume to the minimum. 2. Turn on the intercom. 3. Adjust the scanner’s volume to a comfortable level. The scanner’s audio is heard from both the left and right earpieces. 4. To speak to another person, set MIC GAIN/OFF/MAX on the intercom to the minimum position and press the push-to-talk button on the headset. Speak into the microphone. 5. Adjust the intercom’s MIC GAIN/OFF/ MAX so the sound level of your voice is comfortable to the listener. The persons on the left side hear the voice from the right earpiece and the right side persons hear the voice from the left earpiece. The scanner is heard through the other earpiece. 6. Release the push-to-talk button on the headset when you finish speaking. 7. Turn MIC GAIN/OFF/MAX on the intercom to OFF to turn it off. %#4D Keep the intercom dry; if it gets wet, wipe it dry immediately. Use and store the intercom only in normal temperature environments. Handle the intercom carefully; do not drop it. Keep the intercom away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new. If your intercom is not performing as it should, take it t...