Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
If the Power or Ready LEDs are still blinking or the Over Temp LED is lit, contact your service center. Image Problems Problem: No image appears on the screen 1. Verify the settings on your notebook or desktop PC. 2. Turn off all equipment and power up again in the correct order. Problem: The image is blurred 1. Adjust the Focus on the projector. 2. Press the Auto button on the remote control or projector. 3. Ensure the projector-to-screen distance is within the 10-meter (33-feet) specified range. 4. Check that the projector lens is clean. Problem: The image is wider at the top or bottom (trapezoid effect) 1. Position the projector so it is as perpendicular to the screen as possible. 2. Use the Keystone button on the remote control or projector to correct the problem. Problem: The image is reversed Check the Projection setting on the Installation I menu of the OSD. Problem: The image is streaked 1. Set the Frequency and Tracking settings on the Computer menu of the OSD to the de- fault settings. 2. To ensure the problem is not caused by a connected PC’s video card, connect to another computer. Problem: The image is flat with no contrast Adjust the Contrast setting on the Image menu of the OSD. Problem: The color of the projected image does not match the source image. Adjust the Color Temperature and Gamma settings on the Image menu of the OSD. Lamp Problems Problem: There is no light from the projector 1. Check that the power cable is securely connected. 2. Ensure the power source is good by testing with another electrical device. 3. Restart the projector in the correct order and check that the Power LED is green. 4. If you have replaced the lamp recently, try resetting the lamp connections. 5. Replace the lamp module. 6. Put the old lamp back in the projector and have the projector serviced. Problem: The lamp goes off 1. Power surges can cause the lamp to turn off. Re-plug power cord. When the Ready LED is on, press the power button. 2. Replace the lamp module. 3. Put the old lamp back in the projector and have the projector serviced. Remote Control Problems Problem: The projector does not respond to the remote control 1. Direct the remote control towards remote sensor on the projector. 2. Ensure the path between remote and sensor is not obstructed. 3. Turn off any fluorescent lights in the room. 4. Check the battery polarity. 5. Replace the batteries. 6. Turn off other Infrared-enabled devices in the vicinity. 7. Have the remote control serviced. Audio Problems Problem: There is no sound 1. Adjust the volume on the remote control. 2. Adjust the volume of the audio source. 3. Check the audio cable connection. 4. Test the source audio output with other speakers. 5. Have the projector serviced. Problem: The sound is distorted 1. Check the audio cable connection. 2. Test the source audio output with other speakers. 3. Have the projector serviced. Having the Projector Serviced If you are unable to solve the problem, you should have the projector serviced. Pack the projector in the original carton. Include a description of the problem and a checklist of the steps you took when trying to fix the problem: The information may be useful to service personnel. For servicing, return the projector to the place you purchased it. Projection Distance V.S. Projection Size Tele Wide Distance (m) 1.34 3.58 4.47 8.94 1.54 3.09 3.86 11.58 Diagonal Size (inches) 30 80 100 200 40 80 100 300 Keystone Correction Angle (degree) 12.3 12.3 12.3 12.3 14.2 14.2 14.2 14.2 Image Height (mm) 457 1219 1524 1864 610 1219 1524 4572 Image Width (mm) 610 1626 2032 3762 813 1626 2032 6096 A (mm) (64) (171) (213) (427) (85) (171) (213) (640) Timing Mode Table The projector can display several resolutions. The following table outlines the resolutions that can be displayed by the projector. Signal Resolution H-Sync (KHz) V-Sync (Hz) Composite / S-Video Component RGB NTSC - 15.734 60.0 0 - - PAL/SECAM - 15.625 50.0 0 - - VESA 640 x 350* 31.5 70.0 - - 0 640 x 350* 37.9 85.0 - - 0 640 x 400* 37.9 85.0 - - 0 640 x 480 31.5 60.0 - - 0 640 x 480 37.9 72.0 - - 0 640 x 480 37.5 75.0 - - 0 640 x 480 43.3 85.0 - - 0 800 x 600 35.2 56.0 - - 0 800 x 600 37.9 60.0 - - 0 800 x 600 48.1 72.0 - - 0 800 x 600 46.9 75.0 - - 0 800 x 600 53.7 85.0 - - 0 1024 x 768 48.4 60.0 - - 0 1024 x 768 56.5 70.0 - - 0 1024 x 768 60.0 75.0 - - 0 1024 x 768 68.7 85.0 - - 0 1440 x 900 55.6 60.0 - - 0 1280 x 1024 63.98 60.0 - - 0 1280 x 1024 79.98 75.0 - - 0 1400 x 1050 65.3 60.0 - - 0 1400 x 1050 64.7 60.0 - - 0 1600 x 1200* 75.0 60.0 - - 0 Apple Macintosh 640 x 480 34.98 66.66 - - 0 640 x 480 35.0 66.68 - - 0 832 x 624 49.725 74.55 - - 0 1024 x 768 60.24 75.0 - - 0 1152 x 870 68.68 75.06 - - 0 Signal Resolution H-Sync (KHz) V-Sync (Hz) Composite / S-Video Component RGB SDTV 480i 15.734 60 - 0 - 576i 15.625 50 - 0 - EDTV 480p 31.469 60 - 0 - 576p 31.25 50 - 0 - HDTV 720p 37.5 50 - 0 - 720p 45.0 60 - 0 - 1080i 33.8 60 - 0 - 1080i 28.1 50 - 0 - 0: Frequency supported -: Frequency not...
Эта инструкция также подходит к моделям:Проекторы - DX325 (2.81 mb)