Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
• The language can also be set via the Display setting menu p.54 . • This owner’s manual assumes that English has been selected. 3 Place connected device(s) in operating status. Turn on and boot up connected computers and other devices. 4 Select input. q Press the INPUT button. Computer (1) Y/PB/PR(1) A list of inputs appears on the screen. Computer (2) w Use the buttons to select the desired Y/PB/PR(2) input, and press the button. Video S-video The picture for the selected input is projected. PC Card Camera 27 Operations Basic 5 Projector placement The placement angle the foot adjuster. q Lift up the front of the projector until it is at the desired angle, then press the foot adjuster release button. The foot adjuster extends. Release the button to lock the position. w Turn the foot adjuster to fine-tune the angle. e To adjust the horizontal angle, use the tilt adjuster. 1 2 3 To stow the foot adjuster, hold up the projector while pressing the foot adjuster release button, then slowly lower the projector will the button depressed. 6 Adjusting the picture size and focus q Use the zooming lever to adjust the screen size. w Use the focusing ring to adjust the focus. 1 2 7 Adjusting the volume with the buttons The speaker volume can be adjusted when an audio signal is being input. Notes • Note that the lamp characteristics may rarely cause the brightness to fluctuate slightly. • A lamp is consumable supplies. If used for extended periods, images will appear dark, and the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime of the lamp depends on conditions of use.) • The LCD panel is made using extremely advanced technology, but there may be black spots (pixels that do not light) or bright spots (pixels that are constantly lit) on the panel. Please note that these are not malfunctions. • Although this projector supports a wide range of RGB signals p.68 , any resolutions not supported by the model (XGA or SVGA, depending on the model) will be expanded or shrunk, which will affect image quality slightly. To view high-quality images, it is recommended that the computer’s external output should be set to the projector’s resolution. • With some models of computer having LCD displays or the like, displaying images simultaneously on the projector and the monitor’s display may prevent the images from displaying properly. If this happens, turn off the computer’s LCD display. For information on how to turn off the LCD display, see the owner’s manual of your computer. • If a signal not supported by the projector is input, the icon will appear. • If a no signal is being input from the connected device, the icon will appear. • If an unavailable operation button is pressed, the icon will appear. 28 Using features To operate via the remote buttons, [ PJ MODE] must be selected. Press the PJ Mode The button lights up. This light will go out seconds after operations If necessary, press the but...
Эта инструкция также подходит к моделям:Проекторы - Conference Room Projectors TLP-T400U (3.09 mb)
Проекторы - Conference Room Projectors TLP-T401U (3.09 mb)
Проекторы - Conference Room Projectors TLP-T500U (3.09 mb)
Проекторы - Conference Room Projectors TLP-T501U (3.09 mb)