Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
SELECT/ADJUST AUTO SET POINTER PJ MARKER LASER MENU ENTER KEYSTONE ON/STANDBY R-CLICKL-CLICK VIDEO CAMERA RGB RESIZE RESET AUTO SET ON/STANDBY MENU ENTER INPUT ON LAMP TEMP FREEZERESET 4 1,7 2,3,5,6 1 Press MENU to display the menu. 2 Press or to select . Au t o s y n Image c. Ph a s e – + H – po s i t i on V – po s i t i on Cl o c k – + – + – + 3 Press to select “Auto sync.” 4 Press ENTER. The image is automatically adjusted. For further adjustments, follow the below steps. 5 Press or to select a preferred item. 6 Press or to adjust the item. To select another item, go back to step 5. Phase: To reduce flickers. H-position: To shift the image to the left (–), to the right (+). V-position: To shift the image down (–), to up (+). Clock To remove vertical stripes. CONTENTS 31 Notes • When performing the automatic projection adjustment, use a bright and distinctly edged picture. • Pressing AUTO SET on the remote control can also adjust the image automatically. 23 • If you project an image from a computer with an LCD screen while monitoring the image on the computer, the image may not be projected properly, depending on the computer model. In this case, turn off the computer display, or make the necessary picture adjustments on the projector. For details on controlling the computer display, etc., refer to the computer’s manual and description on the software for the computer used. • During adjustments of “H-position” or “Vposition”, the image may not be projected properly. • While using, an aberration of the phase may occur. In that case, adjust “Phase” again. • Some item may be displayed in gray depending on an input source. The item displayed in gray cannot be adjusted and/or set. • These adjustments are stored until you turn the power off. • To store the adjustments even if the power is turned off, follow the procedure of “Saving data”. 34 • Pressing RESET will return the adjustment or setting currently selected to default. 7 Press MENU. The menu disappears. Adjustments Adjustments – Picture Preparation • Display the image as explained in “Picture Projection”. 21 • Set the POINTER/PJ selector to “PJ”. SELECT/ADJUST ON AUTO SET POINTER PJ MARKER LASER MENU ENTER KEYSTONE ON/STANDBY R-CLICKL-CLICK VIDEO CAMERA RGB RESET FREEZERESIZE RESET ON/STANDBY MENU ENTER INPUT LAMP TEMP 1,5 2-4 1 Press MENU to display the menu. 2 Press or to select . Pi c t ure Contrast – + Br ightness – + Color – + 3 Press or to select a preferred item. Press or to adjust the item. To select another item, go back to step 3. – : + : Contrast : (–) Lower (+) Higher Brightness:(–) Darker (+) Brighter Color: (–) Duller (+) Brighter Tint: (–) Redder (+) Greener Sharpness: (–) Softer (+) Sharper R-level: (–) To reduce red (+) To increase red G-level: (–) To reduce green (+) To increase green B-level: (–) To reduce blue (+) To increase blue 4 Ti nt S h a r pne s s – + – + R-l eve l – + G l eve l – + B l eve l – + C a m e r a g ain – + CONTENTS 32 Camera g...
Эта инструкция также подходит к моделям:Проекторы - Conference Room Projectors TLP-680U (827.7 kb)
Проекторы - TLP-680U (827.7 kb)
Проекторы - TLP-681 (827.7 kb)