Оценок - 2, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
If improperly handled, explosion might result. ..The lamp can easily become damaged if struck against hard objects or dropped, and injury or malfunctions may result. When replacing the lamp, allow it to cool for at least one hour before handling it. ..The lamp cover gets very hot, and touching it can cause burns. Before replacing the lamp, be sure to disconnect the power plug from the wall outlet. ..Electric shocks or explosions can result if this is not done. Do not allow infants or pets to touch the remote control unit. ..Keep the remote control unit out of the reach of infants and pets after using it. ImportantInformation CAUTIONS Do not cover the air inlet port or the air outlet port. ..Doing so may cause the projector to overheat, which can cause fire or damage to the projector. ..Do not place the projector in narrow, badly ventilated places such as closets or bookshelves. ..Do not place the projector on cloth or papers, as these materials could be drawn into the air inlet port. Do not set up the projector in humid or dusty places or in places where the projector may come into contact with oily smoke or steam. ..Using the projector under such conditions may result in fire, electric shocks or plastic deterioration. The plastic deterioration may cause the falling down of the projector which is mounted in the ceiling. Do not set up the projector in a high temperature environment, such as near a heater or in direct sunlight. ..Failure to observe this may result in fire, malfunction or plastic deterioration. Do not set up the projector outdoors. ..The projector is designed for indoor use only. When disconnecting the power cord, hold the plug, not the power cord. ..If the power cord itself is pulled, the power cord will become damaged, and fire, short-circuits or serious electric shocks may result. Always disconnect all cables before moving the projector. ..Moving the projector with cables still attached can damage the cables, which could cause fire or electric shocks to occur. Do not place any heavy objects on top of the projector. ..Failure to observe this may cause the projector to become unbalanced and fall, which could result in damage or injury. ENGLISH - 7 ImportantInformationImportantInformation Precautions with regard to safety Do not short-circuit, heat or disassemble the batteries or place them into water or fire. ..Failure to observe this may cause the batteries to overheat, leak, explode or catch fire, and burns or other injury may result. When inserting the batteries, make sure the polarities (+ and -) are correct. ..If the batteries are inserted incorrectly, they may explode or leak, and fire, injury or contamination of the battery compartment and surrounding area may result. Use only the specified batteries. ..If incorrect or different kind of batteries are used, they may explode or leak, and fire, injury or contamination of the battery compartment and surrounding area may result. Do not mix old and new batteries. ..If the batteries are inserted incorrectly, they may explode or leak, and fire, injury or contamination of the battery compartment and surrounding area may result. Remove the used batteries from the remote control promptly. ..If you leave used batteries in the remote control for an extended period of time, it may cause liquid leaking, abnormal internal temperature rising or explosion. If not using the projector for an extended period of time, disconnect the power plug from the wall outlet and remove the batteries from the remote control. ..If dust builds up on the power plug, the resulting humidity may damage the insulation, which could result in fire. ..Keeping or leaving the remote control with batteries inside may cause insulation deterioration, electrical leakage or explosion which could result in fire. Do not put your weight on this projector. ..You could fall or the projector could break, and injury may result. ..Be especially careful not to let young children stand or sit on the projector. Disconnect the power plug from the wall outlet as a safety precaution before carrying out any cleaning. ..Electric shocks can result if this is not done. If the lamp has broken, ventilate the room immediately. Do not touch or bring your face close to the broken pieces. ..Failure to observe this may cause the user to absorb the gas which was released when the lamp broke and which contains nearly the same amount of mercury as fluorescent lamps, and the broken pieces may cause injury. ..If you believe that you have absorbed the gas or that the gas has got into your eyes or mouth, seek medical advice immediately. ..Ask your dealer about the replacement of the lamp unit and check the inside of the projector. Ask an Authorized Service Center to clean inside the projector at least once a year. ..If dust is left to build up inside the projector without being cleaned out, it can result in fire or problems with operation. ..It is a good idea to clean the inside of the projector before the season for...