In addition, some models may be used in emergency situations. In an emergency situation, be sure to contact a physician or EMS immediately. 4 WARNING: DO NOT reuse plastic crush gaskets (fire risk). Set-Up (Yoke Style) • Inspect the cylinder following the instructions of your gas supplier. Be sure to purge the cylinder valve seat of debris. • Inspect the regulator for oil or grease. If either is visible, DO NOT use the regulator. • Be sure the sealing washer is in place on the inlet of the r
Turn the cylinder off and turn the regulator on to relieve any built-up pressure. Try tightening the regulator to the cylinder and opening the cylinder again. If this does not help, shut the system down again and contact a service representative. NEVER attempt to repair a regulator or cylinder yourself. • Adjust the flow rate setting by turning the knob clockwise until the desired setting shows in the window. • If the cylinder pressure falls below 300 PSI, exchange the cylinder for a full one.
Total bed weight assembled: 154 lb (bed and motor only). UL 73 and CAN/CSA 22.2 No. 68-92 approved. Available with Fiberboard Decorative Walnut Bed-ends or High-impact Plastic Bed-ends. Maximum patient weight 350 lbs. 450 lb evenly distributed total weight capacity including patient mattress, rails, and accessories. Bed Height: Min. 15", Max. 24" (at deck level). Lift Range: Head - 60°, Knee - 30°. Overall Bed Size: 87” L x 36” W. WhisperLite™ II Semi-Electric Bed Motor Unit Warranty: •
Weight Capacity..............................................600 lb Floor Clearance........................................................5.75" Lifting Range Min. Height.........................................27.0" Max. Height..............................................................71.0" Overall Length..........................................................50.0" Overall Width............................................................26.2" Max. Base Width..........................
ne 9V battery (included). • One year limited warranty. GF13602 Patient Alarm with Pull Cord, Small 1 ea GF13602 O- Vi- Patient Alarm with Magnetic Pull Cord • Attached to bed/chair with self contained clip and adjustable cord. • Audio alarm sounds with magnetic pull switch is removed. • Includes ON/OFF switch and dual volumes. • Uses two AAA batteries (included). • One year limited warranty. Graham-Field Health Products 2935 Northeast Parkway Atlanta,Georgia 30360 2006 © Graham-Fie
Patient Alarm A Graham-Field Brand Patient Alarm For Bed and Chair • Alarm includes ON/OFF switch and dual volumes. • Audio alarm sounds when patient gets out of chair or bed • Uses one 9v battery (included). • Six month limited warranty. GF13605 Patient Alarm for Wheelchair Pad Size 10"x15" GF13606 Patient Alarm for Bed Pad size 11"x30" 1 ea 1 ea Patient Alarm With Pull Cord • Attaches to bed/chair with self contained clip. • Audio alarm sounds when pin connector is pulled from the
Turn the T-Handle clockwise until the screw is seated in the dimple on the cylinder valve. Be sure the regulator is tightened securely into the cylinder. • Attach the oxygen supply tubing to the outlet connection of the regulator. Set-Up (H-Nut Style) • Inspect the cylinder following the instructions of your gas supplier. Be sure to purge the cylinder valve seat of debris. • Inspect the regulator for oil or grease. If either is visible, DO NOT use the regulator. • Before attaching the regul
In addition, some models may be used in emergency situations. In an emergency situation, be sure to contact a physician or EMS immediately. 4 WARNING: DO NOT reuse plastic crush gaskets (fire risk). Set-Up (Yoke Style) • Inspect the cylinder following the instructions of your gas supplier. Be sure to purge the cylinder valve seat of debris. • Inspect the regulator for oil or grease. If either is visible, DO NOT use the regulator. • Be sure the sealing washer is in place on the inlet of the r