Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Original instructions: English
3) Hold power tools by insulated
Translation of the original instructions:
gripping surfaces when performing
Other languages
an operation where the cutting tool
This tool, as a complete unit with a battery
may contact hidden wiring; contact
pack, satisfies appropriate IP Degrees of
with a “live” wire wil make exposed
Protection based on the IEC regulations.
metal parts of the tool “live” and shock
the operator.
Definition of IP code
4) Wear a dust mask, if the work causes
IP5X: Ingress of dust is not totally
dust.
prevented, but dust shal not penetrate
5) Be aware that this tool is always in an
in a quantity to interfere with satisfactory
operating condition, since it does not
operation of the tool or to impair safety
have to be plugged into an electrical
(In case that the talcum powder under 75
outlet.
μm intrudes inside the tool) IPX6: Water
6) When drilling or driving into walls,
projected in powerful jets against the tool
floors, etc., “live” electrical wires may
from any direction shal have no harmful
be encountered. DO NOT TOUCH
effects (In case that, with a nozzle of
THE CHUCK OR ANY FRONT METAL
12.5 mm inner diameter, approximately
PARTS OF THE TOOL! Hold the tool
100 L/min of normal temperature water is
only by the plastic handle to prevent
injected to the tool for 3 minutes from 3
electric shock in case you drill or drive
meter distance)
into a “live” wire.
LIMITED WARRANTY
7) I f t h e b i t b e c o m e s j a m m e d ,
The rating of IP56 qualifies this tool for the
immediately turn the trigger switch
minimum impact of water or dust, but not
of to prevent an overload, which can
for the assurance of performance in such
damage the battery pack or motor.
conditions. See Safety and Operating
Use reverse motion to loosen jammed
Instructions for further details for proper
bits.
operation.
8) Do NOT operate the Forward/Reverse
lever when the trigger switch is on.
I. INTENDED USE
The battery wil discharge rapidly and
These tools can be used to tighten
damage to the unit may occur.
screws in clutch mode and to drill
9) During charging, the charger may
holes in wood and metal in drill mode.
become slightly warm. This is normal.
Additionally, model EY7940 can be
Do NOT charge the battery for a long
used to drill holes in soft concrete and
period.
similar materials in hammer mode.
10) When storing or carrying the tool,
set the Forward/Reverse lever to the
Read the Safety Instructions booklet
center position (switch lock).
and the following before using.
11) Do not strain the tool by holding the
II. ADDITIONAL
speed control trigger halfway (speed
SAFETY RULES
control mode) so that the motor stops.
12) Do not operate the speed selector
1) Wear ear protectors.
switch (LOW-HIGH) while pul ing on
Exposure to noise can cause hearing
the speed control trigger. This can
loss.
cause the rechargeable battery to
2) Use auxiliary handle supplied with
wear quickly or damage the internal
the tool.
mechanism of the motor.
Loss of control can cause personal
injury.
- 5 -
EY7441_EY7940_Book.indb 5
2010-6-22 15:57:35
...Эта инструкция также подходит к моделям:
Прочие комплектующие - EY7940 (6.95 mb)