Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Прочие комплектующие - Adaptec RAID 2405 (22.37 kb)
Прочие комплектующие - Adaptec RAID 2405 (22.08 kb)
Прочие комплектующие - Adaptec RAID 2405 (22.76 kb)
Прочие комплектующие - Adaptec RAID 2405 (26.18 kb)
Фрагмент инструкции
The selected disk drive(s) cannot be used until the erase is complete. Stopping a Secure Erase To stop a secure erase in progress: 1 In the main ACU window, select Secure Erase. 2 Select the disk drive being secure erased, then press Ctrl+Q. The secure erase stops and the ACU returns to its main window. Using SerialSelect to Modify Controller Settings The SerialSelect utility is a tool for modifying the settings of your controller and the disk drives connected to it. Opening SerialSelect To open SerialSelect, start the ARC utility (see page 84), select SerialSelect, then press Enter. Follow the on-screen instructions to modify the settings of your controller and connected disk drives as required. Applying Changes and Exiting 1 To exit SerialSelect, press Esc until you are prompted to exit. If you modified any settings, you are prompted to save the changes before you exit. 2 Select Yes to exit, then press any key to restart your computer. Any changes you made take effect after the computer restarts. Appendix C: Using the Adaptec RAID Configuration Utility . 87 Modifying Your Controller’s Configuration Note: Default controller settings are suitable for most computers. Adaptec recommends that you do not change the default setting. To modify your controller’s settings, select Controller Configuration from the main SerialSelect menu. This section describes the controller configuration options. Some options may not be available for your controller. General Controller Settings Note: Default settings are shown in bold type. Option Description Drive’s Write Cache When enabled, write cache is enabled on the disk drive. When disabled, write cache is not used on the disk drive. Caution—When write cache is enabled, there is a slight possibility of data loss or corruption during a power failure. Runtime BIOS When enabled, the controller BIOS allows the controller to act as a bootable device. Disabling the BIOS allows another controller to act as a bootable device. Automatic Failover When enabled, the controller automatically rebuilds an array when a failed disk drive is replaced. When disabled, the array must be rebuilt manually. Array Background When enabled, the controller constantly verifies a redundant array. Note Consistency Check that there may be a significant performance reduction. Default is disabled. Array-based BBS When enabled in systems that support BBS, the controller presents Support attached bootable devices up to the BIOS for boot device selection. This is relevant for logical arrays. Default is disabled. SATA Native Command When enabled, NCQ is enabled. Disable this feature if you want to Queuing (NCQ) attach more than 48 SATA II disk drives. Only available with SATA II disk drives. Physical Drives Display When enabled, connected disk drives are displayed during system Power During POST On Self Test (POST). Displaying the disk drives adds a few seconds to the overall POST time. Default is disabled. DVD/CD-ROM Boot When enabled, the sy...