Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Прочие комплектующие - Adaptec RAID 4805SAS (29.78 kb)
Фрагмент инструкции
AFU.exe . AAxxx01.ufi where xxx is the model number of your controller. 2 Create additional bootable MS–DOS floppy disks and copy each additional AAxxx0x.ufi file to a separate floppy disk. (Some RAID controllers have two UFI files; some have four. Each goes onto its own floppy disk.) 3 To use a menu-based AFU, see the following section. To run the AFU from the command line, see page 97. Running the Menu-based AFU Note: You can also run the AFU from the command line (see page 97). To run the menu-based AFU: 1 Shut down your operating system and reboot to DOS from a bootable MS-DOS floppy disk or from a DOS partition on a bootable drive. (You can use a disk drive connected to the controller you are updating.) 2 At the DOS command prompt, type AFU with no arguments. The AFU’s main menu is displayed. 3 Select Select Controllers, then select the Adaptec RAID controller(s) to be flashed. To update multiple RAID controllers in the same system, update the boot controller’s flash first, restart the computer, then update the flash for the remaining controllers. 4 Select Select an Operation. 5 Choose the operation you want, then follow the on-screen instructions to complete the task: . Update—Updates all the flash components on a RAID controller with the flash image data from the UFI file. . Save—Reads the contents of a RAID controller’s flash components and saves the data to a UFI file, which you can use to restore a RAID controller’s flash if required. . Verify—Reads the contents of a RAID controller’s flash components and compares it to the contents of the specified UFI file. . Version—Displays version information about a RAID controller’s flash components. . List—Lists all supported RAID controllers detected on your system. 6 Complete the flash operation and restart your computer before trying to use the RAID controller again. (You can not use your RAID controller while you are updating its flash.) Appendix E: Using the Adaptec Flash Utility . 97 Running the AFU from the Command Line Note: You can also run a menu-based AFU (see page 96). To run the AFU from the command line: 1 Power off your computer, insert the first AFU floppy disk, then power on your computer. If your computer isn’t set up to boot from the bootable floppy disk, enter the system setup utility to change the setting. 2 At the DOS command, type AFU followed by a command (see page 97) and any switches you want. Note: To find a controller number, type AFU LIST, then press Enter. The AFU processes the command, prompts you to insert additional floppy disks as needed, exits, and reports either success or an error message code. To update a RAID controller’s flash using the command line, see page 100. AFU Commands This section lists the available AFU commands. List Displays the AFU-supported RAID controllers installed on your computer. Also displays the ID numbers assigned to each controller. You don’t have to restart the computer after completing this command. This example...
Эта инструкция также подходит к моделям:Прочие комплектующие - Adaptec RAID 4800SAS (1.36 mb)