Select the controllers you want to update, then click Next. 6 Review the update summary, then click Apply. 7 When prompted, click Yes to begin the update. Caution: Do not power down the controller(s) during the update. 8 When the update is complete, click OK. Then, restart the server(s) to activate the new firmware images. ! Configuring SNMP Support 12 In this chapter... Configuring SNMP Support on Windows.......................................................................... 131 Configuring SNMP Support on Linux................................................................................ 132 Configuring SNMP Support on NetWare ........................................................................... 132 This appendix describes how to configure SNMP support for the ICP Storage Manager software. ICP Storage Manager supports SNMP “gets” and “traps” through the use of an SNMP agent. Chapter 12: Configuring SNMP Support . 131 Configuring SNMP Support on Windows Note: Be sure your Windows installation includes SNMP support. By default, Windows 2000 and Windows XP do not install SNMP. To install and configure SNMP support: 1 Run the ICP Storage Manager installation program (see page 23). SNMP support is installed automatically, unless you choose to not install it. 2 Follow the on-screen instructions to complete the installation, then restart your system. 3 Open the Windows Computer Management tool, then select Services from the tree. 4 Double-click SNMP Service. 5 The SNMP Service Properties window opens. Click the Traps tab, then enter the IP address of each system on which you want to enable traps. 6 Click OK. 7 Start the SNMP service. Chapter 12: Configuring SNMP Support . 132 Configuring SNMP Support on Linux For the Linux operating system, the ICP Storage Manager SNMP agent is a sub-agent that interfaces with the UCD-SNMP agentx architecture. UCD-SNMP is a third-party package for Linux; for information, documentation, and downloads, see To configure SNMP support: 1 Install ICP Storage Manager (see page 23). 2 Add Adaptec OID information and agentx extension information to the snmp.conf. 3 Delete /var/agentx/master (socket file for agentx). 4 Start the snmpd daemon and agentx. 5 Start aus-snmp daemon. Refer to your Linux documentation for information on configuring UCD-SNMP, agentx, and setting up traps. Configuring SNMP Support on NetWare To install ICP Storage Manager SNMP support, at the command prompt type this command, then press Enter: load AUSSNMP.NLM Refer to your NetWare documentation for information on configuring traps. Solving Problems 13 In this chapter... Troubleshooting ICP Storage Manager ............................................................................... 134 Identifying a Failed or Failing Component......................................................................... 134 Recovering from a Disk Drive Failure ......................................................................

Эта инструкция также подходит к моделям:
Прочие комплектующие - ICP9047MA (3.29 mb)
Прочие комплектующие - ICP5805BL (3.29 mb)
- ()
Прочие комплектующие - ICP5125BR (3.29 mb)