Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
The default value is Ye s , which enables Instrumentation Resets. If both the ErrorInstrumentation and the IOInstrumentation options are set to No, this option has no effect. ResetInstrumentationOnDiscovery = [Yes | No] This option tells the ASPI Manager whether or not to issue an Instrumentation Reset to each instrumentation capable driver when that driver is newly discovered. The default value is Ye s , which enables Instrumentation Resets. If both the ErrorInstrumentation and the IOInstrumentation options are set to No, this option has no effect. SMARTPolling = [Yes | No] This option tells the ASPI Manager whether or not to check whether SCSI devices support Predictive Failure Analysis, and if so to monitor them for SMART events. The default value is Ye s , which enables SMART support. Configuration Settings SMARTTest = [Yes | No | testcount] This option tells the ASPI Manager whether or not to enable Predictive Failure Analysis test mode. For debugging purposes, SMART capable devices internally have a test bit which allow them to generate SMART events even when the hardware is not having a problem. The default value is No, which does not enable any SMART debug events. Choosing option Yes turns the SMART debug bit on for all SMART capable devices and leaves it on. Providing a count instead of Yes turns the SMART debug bit on until at least count debug events are seen, then the SMART debug bit is turned back off. More than the requested count of debug events may be generated before the software can turn all debug events off. This option has no effect if SMARTPolling is set to No. ForceHAWide16 = [Yes | No] ForceHAWide32 = [Yes | No] These two options are used to override the information obtained from the operating system driver about whether or not host adapters support Wide SCSI. These switches are especially useful with older drivers that do not report to ASPI whether or not a host adapter supports Wide SCSI. The default value for both switches is No, which forces ASPI to rely upon operating system driver information. If ForceHAWide16 is set to Yes, then all host adapters are assumed to support at least 16-bit Wide SCSI. If ForceHAWide32 is set to Yes, then all host adapters are assumed to support at least 32-bit Wide SCSI. If an operating system driver reports that a host adapter supports 32-bit Wide SCSI when ForceHAWide16 is set to Yes, then that host adapter will still be treated as a 32 bit Wide SCSI device. In other words, these switches may “widen” a host adapter, but will never make it “narrower” than the operating system driver reports. The switch values are only applied when a host adapter is discovered; if a host adapter already exists in the device database then these switches have no effect upon that host adapter or upon subsequently added devices. Therefore, the device database should usually be cleared after changing these switches. Adap...
Эта инструкция также подходит к моделям:Прочие комплектующие - AAA-131SA (664.34 kb)