Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Прочие комплектующие - 3D Mercury (1.52 mb)
Прочие комплектующие - 3D Mercury (1.47 mb)
Прочие комплектующие - 3D Mercury (5.8 mb)
Прочие комплектующие - 3D Mercury (5.59 mb)
Фрагмент инструкции
Please refer to step 4-6. 4-8 Installation of 3.5” Internal Device BayThe 3D Mercury provides built-in bays to accommodate up to 5 hard disc drives (after removal of the tool enclosure). The built-in HDD requires securing runners which can be found in the black tool enclosure. Required Tools: Securing runners (2 per hard disc drive) 4-8-1 Fit the securing runners on both sides of the HDD and slide the HDD into the internal drive bay. LOCKpower connector on t -- --” 4-6-3 Secure the 5.2 ” internal latch. Refer to installation procedure 4-7 Installation of 3.5” Front Device BayInstallation of the 3.5” front device is the same as the 5.25” front devices. Please refer to step 4-6. 4-8 Installation of 3.5” Internal Device BayThe 3D Mercury provides built-in bays to accommodate up to 5 hard disc drives (after removal of the tool enclosure). The built-in HDD requires securing runners which can be found in the black tool enclosure. Required Tools: Securing runners (2 per hard disc drive) 4-8-1 Fit the securing runners on both sides of the HDD and slide the HDD into the internal drive bay. LOCK English 4-8-2 For installation of the 4th and 5th HDDs, remove the tool enclosure and -- 4-8-2 For installation of the 4th and 5th HDDs, remove the tool enclosure and -- 4-8-3 In case the length of the power cable is not sufficient for installation of the bottom HDDs, please use the power extension cable which can be found inside the tool enclosure. Connect it according to the type of the connector of your HDD. 4-9 Application of Security Lock 3D Mercury includes a safety lock on the side panel. Insert the key into the lock and rotate it Supports 90 d di h di 4-10 Application of Foot The 3D Mercury consists of four foot supports for ensuring the casing is firmly seated on the holding surface. Swivel the foot supports 90 degrees according to the diagram to open or retract. Note: When moving or laying down the case, please swivel the foot support to the closed position to prevent bending of the foot supports. 16 17 4-11 Applicatioparent SiRequired Tools: Cross transparent side panel window. a. Open the side panel and lay it on the ground with the inner side facing up. c. Release the plastic clamps and re- move the mesh grid. d. Take the transparent side panel win- dow out from the carton box and remove the plastic protection layer. e. Screw the transparent side panel win- dow onto the side panel with the protrud- 4-12 Application of Liquid Cooling System 4-12-1 CPU water block installation Warning: Be sure to remove the “CAU- TION” sticker from the bottom of the CPU water block. Spread the thermal paste evenly on the CPU surface. 4-11 Applicatioparent SiRequired Tools: Cross transparent side panel window. a. Open the side panel and lay it on the ground with the inner side facing up. c. Release the plastic clamps and re- move the mesh grid. d. Take the transparent side panel win- dow out from the carton box and remove the plastic...