Оценок - 3, средний балл: 4.3 ( )

Производитель: Swisher Размер: 2.46 mb Название файла: Язык инструкции:

• ONLY operate splitter on level ground with wheels blocked, not on the side of a hill. It could. tip, or rolling logs, poor footing, etc. could cause an accident.. 3 • NEVER operate your splitter near a flame or spark. Hydraulic oil and gasoline are flammable and can. explode.. • NEVER fill gas tank while the engine is hot or running. Allow the engine to cool before refueling.. • This unit is equipped with an internal combustion engine and should not be used on or near any. unimproved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is. equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used it. should be maintained in effective working order by the operator.. -NOTE-. In the state of California, the above is required by law (Section 442 of the California Public Resources Code). . Other states may have similar laws. Federal laws apply on federal lands. A spark arrester muffler (optional by. manufacturer) is available at your nearest engine dealer. Check legal requirements in your area.. • ONLY use your hands to operate the control lever. NEVER use foot, knee, rope or any extension device.. • Split ONLY one log at a time. NEVER attempt to split two logs on top of each other.. • NEVER place hands or feet between log and splitting wedge or between log and ram during forward or. reverse stroke. ALWAYS keep fingers clear of splits that open in log during splitting operation.. • DO NOT straddle or reach across the splitting area while operating the splitter.. • DO NOT step over splitter when the engine is running. You may trip or accidentally activate the splitting. wedge. Walk around to get to the other side.. • NEVER attempt to load splitter while splitting wedge is in motion. When loading log splitter, place hands. on the sides of the log, not the ends.. • NEVER attempt to split woods across the grain. Wood may burst or fly out of your splitter and result in. serious injury.. • NEVER leave your splitter unattended with the engine running. Shut off the engine if you are leaving. your splitter, even for a short period of time. Someone could accidentally activate the ram and be injured.. • Both ends of the log should be cut as squarely as possible to prevent the log from sliding out of the splitter. during operation. Log length should be kept to 24” or less.. • NEVER operate your splitter while it is attached to the tow vehicle.. • BEFORE towing, be certain that the splitter is securely attached to the towing vehicle and that the support. leg, beam and cylinder are secured in there respective towing positions.. • NEVER allow persons to ride on splitter. DO NOT carry any cargo or wood on your splitter. It may fall. off and cause an accident.. • DO NOT loosen or remove any hydraulic fitting, line or reservoir cap while your splitter or engine is. running.. • Fluid escaping from a very small hole can almost be invisible. DO NOT check for leaks with your hand. . See maintenance section for instructions. IF injured by escaping fluid, see a doctor at once. Serious. infection or reaction can develop if proper medical treatment is not administered immediately.. • DO NOT operate your splitter in poor mechanical condition or when it is need of repair.. • ALWAYS disconnect the spark plug wire and place the wire where it cannot contact the spark plug, to. prevent accidental starting the engine when setting up, transporting, adjusting or repairing.. 4 TOWING SAFETY. • Do not allow persons to ride on splitter. Do not carry any cargo or wood on your. splitter. It may fall off and endanger vehicles that are following you.. • Be sure support leg is in the travel position and coupling secure. This must also. be retracted so not to interfere while towing. Retract support leg by removing. pin, pivoting up, and replacing pin.. • Never exceed 45 MPH while towing your splitter. Be extra cautious when. traveling over rough terrain, especially over railroad tracks.. • Always be careful while backing your splitter. You could jackknife your log. splitter if not careful.. • Before using splitter, disconnect it from tow vehicle. A log could easily be. pushed forward into the vehicle.. • See tire and wheel specifications for PSI while towing.. • Be aware of the extra length of splitter while turning, parking, crossing. intersections, and in all driving situations.. OPERATION INSTRUCTIONS. POSI-LOCK COUPLER. ADJUST COUPLER LOCKING PRESSURE ON BALL BEFORE USE. PLACE HANDLE IN LOCKED. POSITION WITH BALL IN COUPLER. TIGHTEN LOCKNUT AGAINST TENSION SPRING SO THAT. COUPLER IS NOT LOOSE ON BALL. CORRECT ADJUSTMENT WILL ALLOW HANDLE TO BE. RELEASED WITH MODERATE PRESSURE APPLIED TO HANDLE.. TO OPEN, PULL UP ON COUPLER HANDLE AND ROTATE FORWARD. PLACE COUPLER ON BALL. WHEN BALL IS COMPLETELY NESTED IN BALL SOCKET, ROTATE COUPLER HANDLE. BACKWARD UNTIL HANDLE IS IN LOCKED POSITION.. AFTER TOWING FOR 50 MILES, CHECK COUPLER FOR TIGHTNESS ON BALL. ALWAYS CHECK. TIGH...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: