Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
Do not attempt to adjust pump settings, as they are adjusted by the manufacturer at the factory. 4. Use of incorrect hydraulic fluid will void your warranty. Use only Dexron II automatic transmission fluid or 10W non-foaming hydraulic fluid. 5. The flexible pump coupler must be inspected regularly. Allowing the coupler to deteriorate will void your warranty. Deterioration of spider insert and prolonged use after deterioration will destroy pump bearings and engine bearings, along with total destruc ion of coupler hubs. 6. Improper beam lubrication will cause premature wear and looseness. Lubricate the beam regularly. Lack of lubrication will void your warranty. 7. Improper adjustment of splitting wedge will void your warranty. Become familiar with the proper tolerance required for adjustment of the splitting w jdge as instructed in the adjustment section of this manual. a. If wedge is too loose, cylinder beam e nd wedge wear will result. Allowing the wedge to loosen and be used under operating stress will causa damage which will not be covered under warranty. b. If wedge is too tight, severe beam damage will result which will not be covered under warranty. 8. Warranty card must be mailed or delive ;ed directly to factory. Proper information must be completed and mailed as per instructions. No warranty rscords on file may result in delay. 9. Do not overheat the hydraulic system. E> cessive heat will destroy the hydraulic system with hardened O-rings and excessive friction. 10. Do not attempt to start in temperature!* under 20° F. without pre-heating fluid in reservoir. Excessively cold fluid cannot circulate and draw into pump. Warranty will be void. 11. Repair any leaks in hydraulic system immediately. Unattended leaks will cause air to enter system and/or decrease fluid level in reservoir, causing da mage to the hydraulic system which will not be covered by warranty. NEVER: Use fluid below 0° F., or above 150° F. Use a solid engine/pump coupling Force pump when mounting Operate through relief valve for more than several seconds Attempt to adjust unloading or relief valve settings without pressure gauges Operate with air in hydraulic system Use Teflon tape on hydraulic fittings Warm up engine apart from pump in cold weather Attempt to cut wood across the grain 2 IMPORTANT RULES FOR SAFE OPERATION A THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL /V SAFETY AND/OR PROPERTY OF YOURSELF AND OTHERS. READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL BEFORE AT- Æ^ TEMPTING TO OPERATE YOUR LOG SPLITTER. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL IN-flfcW JURY. WHEN YOU SEE THIS SYMBOL-À HEED ITS WARNING. At DANGER i Your log splitter was built to be operated according to the rules for safe operation in this manual. As with any type of power equipment, carelessness or error on the part of the operator can result in serious injury. If you violate any of these rules, you may cause serious injury to yourself or others. TRAINING 1. Before operating this splitter, read and understand this manual completely. Become familiar with it for your own safety. To fail to do so may cause serious injury. Do not allow anyone to operate your splitter who has not read this manual. Keep this manual in a safe place for future and regular reference and for ordering replacement parts. 2. Never use your splitter for any other purpose than splitting wood. It is designed for this use and any other use may cause an Injury. Your log splitter is a precision piece of power equipment, not a playtoy. Therefore, excercise extreme caution at all times. 3. Never allow children to operate your log splitter. Do not allow adults to operate it without proper instruction. Only persons well acquainted with these rules of safe operation should be allowed to use your log splitter. 4. Only the operator is to be near your log splitter during use. Keep all others, including pets and children, a minimum of 20 feet away from your work zone. Flying wood can be hazardous. If a helper is assisting in loading logs, never activate the control until the helper is clear of the area. More accidents occur when more than one person operates the log splitter than at any other time. 5. No one should operate this unit while intoxicated or while taking medication that impairs the senses or reactions. A clear mind is essential for safety. Never allow a person who is tired or otherwise not alert to use your splitter. A PREPARATION 1. Never wear loose clothing or jewelry that can be caught by moving parts of your log splitter and pull you into it. Keep clothing away from all moving parts of your log splitter. 2. Wear proper head gear to keep hair away from moving parts. Always wear protective hearing devices as needed. 3. Always wear safety shoes. A dropped log can seriously injure your foot. 4. Always wear safety glasses or goggles while operating your splitter. A piece of ...
Эта инструкция также подходит к моделям:Прочие инструменты - 241-623-000 (2.09 mb)