Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
Load the glue sticks into the back of the gun. 2: Press trigger several times until the glue stick is firmly set into the inner tube. 3: Allow the glue gun to warm up for approximately 5 minutes. 4: Squeeze trigger until glue flows from the nozzle. 5: Glue need not be spread. Press surfaces together within 15 seconds. Use of clamps or other holding devices is not necessary. Clean surfaces for best bonding. 6: Unplug glue gun when finished. No clean up required. Never pull the glue stick out the back of the gun. Use 7/i6" glue sticks only. CAUTION: Hot melt glue gets hot! Nozzle area temperature reaches 380°. If accidental contact should occur, do not try to remove the glue. Put in cold water immediately....