Оценок - 2, средний балл: 4.5 ( )

Производитель: RIDGID Размер: 262.9 kb Название файла: Язык инструкции:

–ATTENTION– Read and understand all instructions and warnings before operating or using this product. –NOTICE– Any modification or unintended use of this product shall immediately void all manufacturers warranties. Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or unintended use of this product. PADLOCK INSTALLATION INSTRUCTIONS FOR ALL UNITS U-Bolt 7/8"-1" Figure 3 (measure height when lock is closed) Lock Shackle Figure 1 Figure 2 TOOLS REQUIRED- One wrench with 7/16” socket. PADLOCK INFORMATION- Padlock with 7/8”–1” shackle height (figure 3) (recommended Master No 5 or equivalent, not included). 1. Open your padlock and slide the U-bolt over the lock shackle. 2. Slide the lock through the lock housing on the front of the box (figure 1). 3. Guide the U-bolt through the two holes in the back of the lock housing (figure 2). 4. Secure the U-bolt with the two nylon lock nuts supplied. 5. Repeat the procedure for the second lock. 6. To lock, close lid and push bottom of padlock until lock “clicks” closed. 7. To open, turn key and open lid. 3068-OS PROP-ARM INSTRUCTIONS TOP POINT FOR FIELD DESK CAPABILITY 1. Hold cover in the middle with one hand, pull left prop arm outward and disengage from retaining clasp. 2. Switch hands on cover and repeat (figure 4) for opposite side. 3. Hold the cover at it’s top point with your right hand. With your left hand, slightly pull the locking support arm at the hinge until there is a slight bend (figure 4). 4. Slowly lower cover until it is parallel with the ground. Be sure the prop arms are engaged in slots as shown below (figure 5). Make sure prop arms are fully engaged forward so that the prop arms are perpendicular to the cover. 5. The final position for Field Desk Capability is shown in Figue 6 3068-OS,PropArm-1.eps PROP ARM LOCKING SUPPORT ARM Figure 4 3068-OS,PropArm-2.epsENGAGEMENTPOINT SIDE VIEW Figure 5 Figure 6 WARNING Do NOT use cover as a step. 2 2048-OS AND 204830-OS FLEXI-SHELF™ INSTRUCTIONS FOR REMOVING THE SHELF FROM BOX 2048-OS,FlexiShelf-1.eps 1. Be sure all contents are removed from shelf. 2. Securely grasp shelf at the right side (facing box) with both hands and gently lift (figure 7). 3. Remove from box and store properly. Figure 7 2048-OS,FlexiShelf-2.eps ADJUSTING THE FLEXI-SHELF™ FOR YOUR STORAGE NEEDS To adjust dividers: 1. Gently lift dividers straight up while holding down shelf with other hand. 2. Remove divider to desired storage location and reverse procedure (figure 8). Securing shelf for transport: 1. To minimize movement during transport, make sure the shelf front is located behind the stop tabs on each side of the box. 2. Once the box is on-site the shelf can be moved forward by slightly lifting the front edges over the stop tabs. The shelf bottom should always lie flat on the runners when finished adjusting the shelf. "RapidPassThru"-1.eps STOP TAB HAND TOOL STORAGE SCREWDRIVER Figure 8 TO INSTALL RAPID PASS™ GROMMET (M...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: