Оценок - , средний балл: ( )

Инструкция по эксплуатации Briggs & Stratton, модель 25540

Производитель: Briggs & Stratton
Размер: 665.58 kb
Название файла:

Язык инструкции:

Документ загружается, подождите пожалуйста

Скачать инструкциюЗакрыть

Документ загружается, подождите пожалуйста

Скачать инструкциюЗакрыть

HAZARD SYMBOLS AND MEANINGS Explosion Toxic Fumes Moving Parts Hot Surface Shock Kickback Fire (OVER) FORM MS-6445-01/03 ENGINE SELECTION WARNING Failure to select the correct engine could result in fire or explosion. • Some engines are unique and designed for specific applications or types of equipment. If this engine will be used to build new equipment, contact Briggs & Stratton to ensure that the engine is appropriate for the intended use. Note: For all Go-karts use only a model 136200 series en- gine, which offers improved safety and performance. • Replacement engines should be the same model as the original engine, or be the Briggs & Stratton designated replacement engine. Refer to the Operation & Maintenance Instructions for engine identification information. Note: For all Go-karts use only a model 136200 series en- gine, which offers improved safety and performance. • Do not use Briggs & Stratton engines on 3-wheel All -Terrain Vehicles (ATVs), motor bikes, air craft products, or vehicles intended for use in competitive events. Briggs & Stratton does not approve of or authorize such uses. ENGINE INSTALLATION [1] Do not attempt to install this engine if you do not have the appropriate tools and knowledge of small engine installation procedures. Use only Briggs & Stratton parts. Contact your Authorized Service Dealer for assistance. [2] Do not modify the engine in any way without Briggs & Stratton factory approval. Any such modification is at the owner.s sole risk. [3] If the exhaust system on the old engine was supplied by the equipment manufacturer, you must transfer the exhaust system and related components (original muffler and related pipes, brackets, clamps, and shields) to the new engine. All components must be in good condition. [4] WARNING Install muffler (and muffler deflector if used) so outlet points away from operator, fuel tank, and equipment, and so muffler heat will not damage or deform engine and components. [5] WARNING Ensure all fuel lines and fittings are properly assembled and do not leak. Replacement parts must be the same model as the original. [6] WARNING Ensure all wiring, including safety switches and engine shut-off components are completely installed and functioning properly. [7] Set engine speed to equipment manufacturer.s specification. Refer to equipment manufacturer.s manual. Do not tamper with governor springs, or other parts that will increase engine speed above specification. [8] WARNING All engine parts, including fuel cap, spark plug, muffler, air cleaner, and covers and guards for drive components (gears, belts, shafts, couplings, etc.) must be in place before attempting to start engine. [9] WARNING If engine is installed on walk behind lawn mower, all mower components, including cutting blade, must be correctly installed before attempting to start engine. [10] WARNING When working on the engine or equipment, remove spark plug wire from spark plug. For electric start, remove negative wire from battery. [...