Оценок - 4, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
If damage is suspected, return the appliance to the nearest Sunbeam Appointed Service Centre for examination, repair or adjustment. 13. For additional protection, Sunbeam recommend the use of a residual current device (RCD) with a tripping current not exceeding 30mA in the electrical circuit supplying power to your appliances. 14. Do not immerse the appliance in water or any other liquid unless recommended. Features of your Sunbeam Reflexology Foot Spa Control dial Anti Splash cover Removable rollersMassage nodesAir jetsMassage roller attachment Control dial settings Three attachments: Reflexology attachment Massage roller attachment Massage node attachment Using your Reflexology Foot Spa 1.Ensure that the control dial is in the ‘O’ OFF position. 2.Place the product on a firm, level floor. 3.Place a chair behind the unit and adjust its position until you can sit comfortably with your feet inside the appliance (without water). 4.Place a towel within easy reach to dry your feet afterwards. 5.Using a large jug, fill the foot massager with water. Do not fill above the maximum level indicated. 6.Do not use hot water as this will make your feet sweat. 7.Insert the plug into a 230-240 volt power outlet and turn on. 8.Sit in the chair and place your feet in the appliance. 9.Turn the control dial to the setting you wish to use Help Line Massage and Heat To increase the intensity of the massage, move your feet backwards and forwards over the rollers in the base of the product. If the rollers are not required simply remove and replace with the plain insets. The water will remain at an agreeable temperature. Please note that the product will not heat cold water but will simply help to prevent warm water from going cold. Bubble and Heat Use the heat setting along with spa bubbles. Massage, Heat and Bubble Use all three settings together. The removable Massage attachments can be interchanged to give feet the desired reflexology massage. Please refer to the enclosed Guide to Reflexology. If you have any additional questions about using the Reflexology Foot Spa please call the Sunbeam help line in Australia on 1 800 025 059. In New Zealand please call (09) 912 0747 Care and Cleaning 1.With dry hands turn the control dial to the ‘O’ OFF position. 2.Turn the power off and remove the plug from the power outlet. 3.Rinse the inside of the appliance with warm water. 4.Do not immerse the appliance in water or any other liquid. 5.The inside of the appliance, the attachments and the exterior walls can be wiped over with a cloth dampened in water and a mild detergent. Then rinse and dry. 6.The attachments can be washed in a mild detergent. Dry thoroughly before using again. Sunbeam is a registered trademark. Made in China. Due to minor changes in design or otherwise, the product may differ from the one shown in this leaflet. Approved by the appropriate Electrical Regulatory Authorities. Backed by Sunbeam‘s 12 Month Replacement Guarantee and National Service Network. © Copyright. SUNBEAM CORPORATION LIMITED 2002. (INCORPORATED IN N.S.W.) A.C.N. 000 006 771 For more information or advice on this or any other Sunbeam appliance, visit or contact the Sunbeam Consumer Service Line. Australia 1800 025 059 New Zealand (09) 912 0747. Therapeutics Consumer Hotline Australia 1800 025 059 New Zealand (09) 912 0747 Consumer information: 1800 025 059 or is a registered Trademark of Sunbeam Corporation Limited. ACN 000 006 771. © Sunbeam Corporation Limited 2002. ...
Эта инструкция также подходит к моделям:Прочие аксессуары для дома - FB3500 (946.1 kb)