Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
If your spa is no longer under warranty, contact a local spa and pool service provider. 5. SYMPTOM: THE PUMP IS NOISY WHILE OPERATING a. There may be debris in the pump. Contact our customer service department. b. The pump may have a bad bearing. Contact our customer service department. 6. SYMPTOM: THE WATER DOES NOT HEAT a. Make sure that the hydrotherapy spa is fully covered with the spa cover. The spa cover must be tight for the water to heat. Set the air control to low. The water will heat at a rate of 6°F per hour. If you are using the spa indoors and the room temperature is maintained at 70°F, it will take approximately 6 to 8 hours for the water to reach the set temperature. b. If you are using the hydrotherapy spa outdoors, it may take longer for the water to heat. See the chart below for the approximate heating time. Air Temperature Heating Time 70°F + 6 to 8 hours 50°F to 70°F 9 to 11 hours 30°F to 50°F 12 to 14 hours If the water still has not heated after four days, contact our customer service department. CLEANED BY THE FILTER a. Check to see if the filter cartridges are in place. Clean the cartidges if they are dirty. b. Check the chemical balance of the water. If the pH is incorrect, the sanitizing agents will not function properly. See the section on maintaining the proper pH balance on page 13. 8. SYMPTOM: THE WATER PULSATES OR THERE IS MINIMUM WATER FLOW a. This usually occurs only when the water level is low. Add water until it is 2 to 4” above the Basket. 9. SYMPTOM: THE WATER LEVEL DROPS a. A clamp or seal inside the pump compartment may be loose. Check inside the pump compartment for excess water and watch the pump unit while it is operating to see if water drips from any of the plumbing. If you can identify the location of the leak inside the spa jet unit, tighten the clamp or replace the damaged seal. b. Some water loss due to evaporation is normal. If rapid water loss occurs, or if you notice wetness on the floor around the hydrotherapy spa, the spa shell may have a leak. Contact your local pool and spa service provider for repairs. 10. SYMPTOM: THE SPA JET UNIT CONTINUES TO RUN AFTER IT HAS BEEN SHUT OFF a. To turn the main jets off, press the pump button once or twice. Note: If the actual spa water temperature is below the set temperature, or if the spa is running a filter cycle, the heater pump/motor will not shut off. 17 Part List—Model No. PFSG51030 R0203A Key No. Qty. Description 1 8 Buckle Screw 2 4 Buckle 3 4 Corner Panel 4 8 1/4” Washer 4 Rubber Insulator 6 1 Blue Lens 7 1 Waterfall Knob 8 2 2” O-ring 9 2 Removable Collar 2 Filter Cartridge 11 2 Hinge Pin 12 8 *10 x 1” Screw 13 1 Pump Motor* 14 1 Control Unit* 2 Long Panel 16 2 Heater Gasket 17 2 Air Control Knob 18 1 Spa Cover 19 1 Red Lens 2 Suction Cover Assembly 21 1 Diverter 22 1 Basket 23 10 #8 x 1 1/2” Screw 24 1 Filter Door 3 Adjustable Pulsating Jet 26 3 Adjustable Swirl Jet 27 2 Small Adjustable Rotary Jet Key No. Qty. Description 28 1 O-ring 29 1 Drain Plug 30 6 Small Directional Jet 31 2 Short Panel 32 1 Diverter Valve 33 1 Trim Plate 34 1 Filter Door Foam 35 36 #10 x 2” Panel Screw 36 1 Filter Housing* 37 1 Console With Overlay 38 1 Console Overlay 39 1 Motor Pad 40 1 Power Cord # 2 Key # 1 User’s Manual # 1 Light Bulb # 2 Ground Wire # 1 Warning Sign # 1 Warning Sign, Drowning * Indicates a part that is serviceable only by service technicians. # Indicates a non-illustrated part. Specifications are subject to change without notice. 18 19 Exploded Drawing—Model No. PFSG51030 R0203A 1 2 2 6 17 18 19 25 26 27 30 36* 20 24 34 32 33 21 22 10 23 4 28 5 13* 29 12 8 15 31 35 35 35 35 35 3 3 3 11 11 7 12 14* 12 12 16 16 9 9 40 Ordering Replacement Parts To order replacement parts, simply call our Customer Service Department toll-free at 1-877-897-7493, Monday through Friday, 8 a.m. until 5 p.m. Central Time (excluding holidays). To help us assist you, please be prepared to give the following information when calling: • The MODEL NUMBER of the product (PFSG51030) • The NAME of the product (PROFORM ORBIT hydrotherapy spa) • The SERIAL NUMBER of the product (see the front cover of this manual) • The KEY NUMBER and DESCRIPTION of the desired part(s) (see the PART LIST and EXPLODED DRAWING on pages 18 and 19) Limited Warranty ICON Health & Fitness, Inc. (ICON), warrants this product to be free from defects in workmanship and material, under normal use and service conditions, for a period of ninety (90) days from the date of purchase. ICON extends a limited five (5) year warranty on the spa shell structure. ICON extends a limited two (2) year warranty on the pump, motor, and electronics package. This warranty extends only to the original purchaser. ICON's obligation under this warranty is limited to replacing or repairing, at ICON's option, the product through one of its authorized service centers. All repairs for which warranty claims are made must be pre-authorized by ICON. This warranty does not extend to any product or da...