Оценок - 4, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
Remove time. the filter from the filter housing and clean or replace the filter (see page 15). Air Temperature Heating Time 70°F + 6 to 8 hours b. The pump may have a foreign object stuck in 50°F to 70°F 9 to 11 hours the impeller. Contact our customer service 30°F to 50°F 12 to 14 hours department. If the water still has not heated after four days, c. The pump may have a loose wire connection. contact our customer service department. Contact our customer service department. 7. SYMPTOM: THE WATER IS NOT BEING 4. SYMPTOM: THE PUMP HUMS, BUT DOES NOT CLEANED BY THE FILTER ROTATE a. Check to see if the filter are in place. Clean the a. The pump may be jammed. Contact our cus- filter if they are dirty. tomer service department. If your spa is no longer under warranty, contact a local spa and b. Check the chemical balance of the water. If the pool service provider. pH is incorrect, the sanitizing agents will not function properly. See the section on maintain 5. SYMPTOM: THE PUMP IS NOISY WHILE ing the proper pH balance on page 16. OPERATING 8. SYMPTOM: THE WATER PULSATES OR a. There may be debris in the pump. Contact our THERE IS MINIMUM WATER FLOW customer service department. a. This usually occurs only when the water level is b. The pump may have a bad bearing. Contact low. Add water until it is 2” to 4” above the our customer service department. skimmer basket. b. The filter cover may not be tight. Make sure the filter cover is tight. 19 9. SYMPTOM: THE WATER LEVEL DROPS 11. SYMPTOM: THE CONSOLE DISPLAYS “OHH,” “ICE,” “CLD,” “SNA,” “SNB,” “SNS,” “HFL,” a. A clamp or seal inside the pump compartment “LF,” “DR,” or “DRY” may be loose. Check inside the pump compartment for excess water and watch the pump unit a. If the console displays one of the messages while it is operating to see if water drips from listed above, or if the console does not function any of the plumbing. If you can identify the correctly, please call our Customer Service location of the leak inside of the spa jet unit, Department toll-free at 1-877-897-7493, tighten the clamp or replace the damaged seal. Monday through Friday, 8 a.m. until 5 p.m. Central Time (excluding holidays). b. Some water loss due to evaporation is normal. If rapid water loss occurs, or if you notice wetness on the floor around the hydrotherapy spa, the spa shell may have a leak. Contact your local pool and spa service provider for repairs. 10. SYMPTOM: THE SPA JET UNIT CONTINUES TO RUN AFTER IT HAS BEEN SHUT OFF a. To turn off the main jets, press pump button 1 once or twice. Note: If the actual temperature of the water in the spa is below the set temperature, or if the spa is running a filter cycle, the heater pump/motor will not shut off. 20 NOTES 21 Part List—Model No. PFSB73930 R0303A Key No. Qty. Description 1 1 Console With Overlay 2 2 3-wire Power Cord 3 1 Filter Cover 4 8 Rubber Washer 5 1 Filter 6 2 Rubber Isolator 7 1 Blue Light Cover 8 1 Red Light Cover 9 4 #10 x 1 1/2” Sheet Metal Screw 10 1 2-speed Pump* 11 1 Spa Cover 12 9 Dual Rotary Jet Face 13 4 Jet Pump/Motor O-ring 14 1 Controller* 15 3 Medium Jet Housing 16 1 Cartridge Plug 17 4 Suction Cover Assembly 18 4 Air Control Knob 19 1 1-speed Pump* 20 1 4-wire Power Cord 21 1 Diverter 22 1 Basket 23 8 1/4” Lock Washer 24 1 Filter Housing Door 25 1 Access Panel 26 4 Buckle 27 8 #4 x 3/4” Screw 28 10 1/4” x 1 1/2” Screw 29 1 Overlay 30 1 Whirlpool Jet 31 14 1/4” Washer 32 1 Face Plate Assembly 33 3 Panel 34 2 Heater Collar With Screw 35 1 Volcano Jet Key No. Qty. Description 36 3 Nozzle Housing 37 21 Small Rotator 38 1 Large Rotary Jet 39 1 Face Ring 40 1 Small Nozzle 41 22 Jet Ring 42 1 Nozzle Bushing 43 21 Pivot Ring 44 3 Medium Nozzle 45 2 Drain Plug 46 32 #10 x 2” Machine Screw 47 2 Pillow 48 2 Drain Plug O-ring 49 4 Corner Panel 50 2 Neck Jet 51 1 Filter Housing* 52 9 Dual Rotary Jet 53 2 Heater Gasket 54 2 Waterfall Valve 55 10 Air Injector Assembly 56 1 Blower # 2 Ground Wire # 2 Key # 1 User’s Manual # 1 Large Warning Sign # 1 Warning Sign # 1 LED Light * Indicates a part that is serviceable only by service technicians. # Indicates a non-illustrated part. Specifications are subject to change without notice. 22 26 27 25 18 29 18 11 20 12 2 15 37 43 44 36 40 39 41 42 41 38 35 46 46 46 46 33 9 47 14* 9 9 30 52 50 50 53 53 49 7 8 34 34 1 54 54 51* 5 22 3 21 16 24 32 2 13 19* 28 23 31 13 6 45 48 23 31 4 13 10* 28 13 6 45 48 23 31 23 31 4 55 17 17 17 17 31 28 28 31 56 31 9 31 31 31 Exploded Drawing—Model No. PFSB73930 R0303A 23 Ordering Replacement Parts To order replacement parts, simply call our Customer Service Department toll-free at 1-877-897-7493, Monday through Friday, 8 a.m. until 5 p.m. Central Time (excluding holidays). To help us assist you, please be prepared to give the following information when calling: • The MODEL NUMBER of the product (PFSB73930) • The NAME of the product (PROFORM MAGNA hydrotherapy spa) • The SERIAL NUMBER of the product (see the front cover of this manual) • The KEY NUMBE...