Войти:
Оценок - 3, средний балл: 4.3 ( )

Инструкция по эксплуатации Avanti, модель IMP25

Производитель: Avanti
Размер: 272.19 kb
Название файла: imp25.pdf
Язык инструкции:enes
Перейти к скачиванию



Фрагмент инструкции


Danger or Warning: risk of child entrapment. Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances are still dangerous. . . Even if they will “just sit in the garage a few days.” Before you throw away your ice maker: take off the door. Leave the shelves in place so that children may not easily climb inside. Never allow children to operate, play with, or crawl inside the appliance. Never clean ice maker parts with flammable fluids. The fumes can create a fi re hazard or explosion. Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any other ice maker. The fumes can create a fire hazard or explosion. -save these instructions INSTALLATION INSTRUCTIONS • Before Using Your Ice Maker ? Remove the exterior and interior packing. ? Check to be sure you have all of the following parts: ? 1 Ice Shovel ? 1 Instruction Manual ? Before connecting the ice maker to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. ? Clean the interior surface with lukewarm water using a soft cloth. • Installation Of Your Ice Maker ? Locate the ice maker away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the ice maker not to perform properly. ? Plug the ice maker into an exclusive properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and or grounding should be directed toward a certified electrician or an authorized Avanti products service center. 9 • Electrical connection ?WARNING• IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS SERVICE CENTER. ? This ice maker should be properly grounded for your safety. The power cord of this ice maker is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock. ? Do not under any circumstances cut or remove the third ground prong from the power cord supplied. ? Never use an extension cord to connect power to the unit. ? Never use a two -prong grounding ad apter. ? Where a two-prong wall receptacle is encountered, contact a qualified electrician to have it replaced with a 3-prong receptacle in accordance with applicable electrical codes. ? This ice maker requires a standard 115/120 volts a.c.~/60hz electrical outlet with three -prong ground. ? The cord should be secured behind the ice maker and not left exposed or dangling to prevent accidental injury. • Extension cord Because of potential safety hazards under certain conditions, it is strongly recommended that you do not use an extension cord with this appliance. However, if you must use an extension cord it is absolutely necessary that it be a UL/CUL -listed, 3-wire grounding type appliance extension cord having a grounding type plug and outlet and that the electrical rating of the cord be 115 volts and at least 10 amperes. OPERATING YOUR ICE MAKER • Control Panel Operation Start Press to turn unit on. This button is also used to start the ice making cycle. Stop Press to turn unit off. Select ICE SIZE SELECTION of (S) small, (M) medium or (L) large. (The chosen mode shall stay as selected unless changed or there is a power failure). Please select the (S) when ambient temperature is below 15°C (59.F). Alert ADD WATER INDICATOR. The ”Alert ” light will come on with a beep sound. Add water and press “STOP” button and then press “START” button to restart the icemaker. Ice Full ICE FULL INDICATOR. This light will come on with a beep sound which indicates that the storage cabinet is full. Press the “STOP” button and remove the ice cubes then, press the “START” button to restart the Ice maker. IMPORTANT: YOU MUST PRESS “STOP”. THEN THE “START” BUTTON TO RESTART THE ICE MAKER AFTER YOU ADD WATER OR REMOVE SOME OF THE ICE CUBES. 10 Operating Instructions Starting your Ice maker ? Open the lid and fill the reservoir with water. Make sure the water level in the reservoir is not over the Ice collecting tray. ? Press START button to turn unit on. ? Select desired ice cube size by pressing “ice size” selectors S, M and L. ? Check the water level in the reservoir periodically. The ice maker will detect any shortage of water and stop operating. The ALERT indicator will be lit. Press the STOP button and fill the reservoir with water. Wait 3 minutes after the ALERT light goes out and then press the START button. The Ice maker will begin operation. ? When the ice cubes are collected and reaches the bin sensor, the ice maker will stop operating and the ICE FULL indicator will be lit. ? There are three...

Эта инструкция также подходит к моделям:
Прочая кухонная техника - IMW24 (272.19 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории