Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
(3 mm) from the top of the cabinet opening. You can adjust the height of the compactor by turning the screws on the front leveling legs and rear wheels. • Place a level inside the compactor on the floor of the cabinet. • Use the leveling legs to adjust level front to back and side to side. Front leveling legs Rear wheels ADJUST THE RETAINING BRACKET 3 • Determine installation depth of the compactor beneath the countertop. • Adjust the position of the retaining brackets so that the screws can meet the underside of the countertop. • Mounting clips are provided for stone or other hard countertops that will not accept screws. Retaining bracket Countertop 4 ADJUSTING THE BASE TOEKICK A toekick extension is supplied. It can be used to cover any gaps from the bottom of the compactor to the floor. • Remove the top toekick screws as shown. Lift off top toekick piece. • Loosen the base toekick screws, adjust to touch the floor and tighten the screws. • Reinstall the top toekick piece with the original screws. Loosen screw on each side Top toekick Adjustable lower toekick Installation • Use two #8-18 x 1/2. (45.7 cm x 1.3 cm) mounting screws to fasten the retaining brackets at the top of the compactor to the underside of the countertop. • If the brackets cannot be attached to the underside of the countertop, attach mounting clips to the bracket. Fasten the compactor to the cabinet front with mounting screws through the mounting clips. POSITION COMPACTOR UNDER THE COUNTERTOP 5 WARNING! When moving the compactor, use gloves to protect and cushion your hands. To protect the finished flooring, use a dolly to move the compactor near the installation location. Failure to follow these instructions could result in injury. • Plug the power cord into a properly grounded receptacle. • Carefully lift the front of the compactor slightly and roll the unit into the cabinet opening until the retaining brackets stop. Lift here ATTACH THE COMPACTOR TO THE COUNTERTOP 6 Mounting screws Retaining bracket Mounting screw Retaining bracket Mounting clip 8 9 Installation • Grasp the sides of the drawer. Carefully slide the drawer into the compactor. REINSTALL THE COMPACTOR DRAWER 7 • Set the bag caddy into the drawer and hook the pre-punched holes in the caddy on the drawer buttons. • Set the trash bag into the bag caddy and fold over. • Hook the holes in the bag over the drawer buttons. INSTALLATION OF THE TRASH BAG CADDY (on some models) 8 Drawer buttons Trash bag caddy • Turn power on at the source. • Refer to your Owner’s Manual for operating instructions. 9 FINALIZE THE INSTALLATION Notes 10 Notes 11 NOTE: While performing installations described in this book, safety glasses or goggles should be worn. NOTE: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice. GE Consumer & Industrial Appliances General Electric Company Louisville, KY 40225 ge.com Pub. No. 31-30596 206C1559P14...
Эта инструкция также подходит к моделям:Прочая кухонная техника - Built-In Compactors GCG1500 BB (714.37 kb)
Прочая кухонная техника - Built-In Compactors GCG1500 WW (714.37 kb)
Прочая кухонная техника - Built-In Compactors GCG1700 II (714.37 kb)
Прочая кухонная техника - Built-In Compactors ZCGP150 II (714.37 kb)