Оценок - 3, средний балл: 4.7 ( )

Производитель: Follett Размер: 670.73 kb Название файла: b8e9e4ab-69d6-48f1-a990-e2ec928ffdb0.pdf Язык инструкции:

This often happens if ice has been held in storage for a period of time without use. Use supplied paddle accessory to break up bridges (see caution below): 1. Completely knock down all ice from sides and back of bin. 2. Knock down any bridge that has occurred in middle. 3. Agitate paddle back and forth to break up congealed ice mass. A Do Not dig up at ice. Instead, break away “legs” that are holding bridges. Ice above will then fall. To avoid injury, do not attempt to break up bridged ice through upper windows or hopper shutter door. A falling ice bridge can cause paddle to lift. Keep head and face away from paddle handle to avoid injury. SMARTGATE operation SMARTGATE can be adjusted and locked at one of several levels to accommodate flow characteristics of different types of ice. Bin is shipped with SMARTGATE in full down position. SMARTGATE can be raised and locked in higher position for better flow or when more access is needed. 5 Cleaning A Clean and sanitize bin and cart(s) interiors prior to use and on regular schedule as needed. use non-chlorine based cleaner and sanitizer suitable for use in a food zone. Do Not use chlorine-based cleaners, which can cause staining and pitting of stainless steel components. Do not run Totes through a dishwasher. Turn off icemaker(s) and remove ice from bin before beginning. Bin drain system cleaning 1. Remove upper tray(s) and wash with cleaning solution, rinse and reposition in brackets. 2. Saturate a cloth with cleaning solution and insert through a loop in end of a piece of wire. 3. Feed wire through vertical drain tube, and pull wire and cloth through tube. 4. Pour 1 gallon (4L) hot water into lower drain trough. drain tray cleaning 1. Remove two thumbscrews on side of drain tray and pull drain tray forward to remove. 2. Wash with an approved cleaner. Shutter doors and rails 1. Support hopper shutter door with one hand and remove thumbscrews from side of hopper shutter door at under side of base section. 2. Pivot door down to remove. 3. Wash door, rinse thoroughly and sanitize. 4. Remove thumbscrews holding front and rear of shutter tracks. 5. Wash tracks, rinse thoroughly and sanitize. Cart and cart drain system 1. Wash cart liner with an approved cleaner. 2. Rinse and sanitize. Cleaning bin before use and ongoing bin maintenance Interior of bin must be cleaned and sanitized prior to use and should be cleaned on routine basis during use (see next page). 6 Interior bin care Follett ice storage bins with SMARTGATE are equipped with polyethylene liner walls which should be cleaned and sanitized periodically with Ecolab Mikro-chlor Cleaner or any product suitable for use in a food zone. Important: Follett Corporation recommends installing a properly-sized, activated carbon (charcoal) water filter on water supply to icemaker to remove chlorine. 1. Remove upper inspection windows by sliding windows to one side. Grasp the end of the front window and pull toward you as t...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: