Оценок - 3, средний балл: 4.7
(
)
)
|
Фрагмент инструкции
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. WARNINGFOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Canada United States GENERAL INFORMATION - The Warmer Drawer can IMPORTANT: The warmer drawer must be installed on a be used as a stand alone appliance or as a combination surface leveled from left to right, rear to front and the surface Warmer Drawer with a built-in oven mounted above. must be capable of supporting 100 pounds (45,4 Kg). D AB F E C FLOOR Warmer Drawer Cutout Warmer Drawer 60" (152,4 cm) Cord Minimum distance to floor 4." (11,4 cm) Warmer DNOTE: A 60" (152,4 cm) long cable is supplied with the Warmer Drawer. Stand Alone Installation rawer Dimensions IMPORTANT: The Warmer Drawer runs off a single phase three-wire 120 volt, 60 hertz, AC only electrical supply with ground. Combination Warmer Drawer / 27" (68,6 cm) or 30" (76,2 cm) Built-in Oven Installation H* =11 7/8" (30,2 cm) Min. is the space between the bottom of the drawer cutout and the bottom of the Bottom of oven cutout Caution: Two 3" (7,6 cm) wide X ." (1,9 cm) thick planks have to be installed and they should be able to support 200 pounds (90,7 Kg). 29 1/16" (73,8 cm) oven cutout. This is a critical dimension and must be provided. J** = 3" (7,6 cm) Max. Electrical Junction Box for wall oven can be lower than warmer drawer cutout. A. HEIGHT B. WIDTH C. DEPTH A. HEIGHT B. WIDTH C. DEPTH 27" Models 11 ." (28,6 cm) 27" (68,6 cm) 23 3/8" (59,4 cm) 27" Models 11 ." (28,6 cm) 27" (68,6 cm) 23 3/8" (59,4 cm) 30" Models 11 ." (28,6 cm) 30" (76,2 cm) 23 3/8" (59,4 cm) 30" Models 11 ." (28,6 cm) 30" (76,2 cm) 23 3/8" (59,4 cm) D. CUTOUT HEIGHT E. CUTOUT WIDTH F. CUTOUT DEPTH D. CUTOUT HEIGHT E. CUTOUT WIDTH F. CUTOUT DEPTH G. HEIGHT 27" Models - Min. Max. 9 7/8" (25,1 cm) 10 ." (26 cm) 25 ." (64,8 cm) 25 ." (65,4 cm) 23 5/8" (60 cm) 24" (61 cm) 27" - Min. Max. 9 7/8" (25,1 cm) 10 ." (26 cm) 25 ." (64,8 cm) 25 ." (65.4 cm) 23 5/8" (60 cm) 24" (61 cm) 2" (5,1 cm) Depends on critical dimension H 30" Models - Min. Max. 9 7/8" (25,1 cm) 10 ." (26 cm) 28 ." (72,4 cm) 28 ." (73 cm) 23 5/8" (60 cm) 24" (61 cm) 30" - Min. Max. 9 7/8" (25,1 cm) 10 ." (26 cm) 28 ." (72,4 cm) 28 ." (73 cm) 23 5/8" (60 cm) 24" (61 cm) 2" (5,1 cm) Depends on critical dimension H * Note: It is also possible to install this warmer drawer in a height opening P/N 318201822 (0901) Rev. A English – pages 1-4 of 9." (23,5 cm). Please refer to page 3 for complete instructions. Espanol – paginas 5-8 Francais – pages 9-12 Printed in United States 1 WARMER DRAWER INSTALLATION INSTRUCTIONS WARMER DRAWER INSTALLATION INSTRUCTIONS Important Notes to the Installer 1. Read all the instructions contained in these installation instructions before installing appliance. 2. Remove all packing material from the appliance before connecting the electrical supply. 3. Observe all governing codes and ordinances. 4. Be sure to leave these instructions with the consumer. Important Note to the Consumer Keep these instructions for future reference. IMPORTANT SAFETY INSTRUCTIONS • Be sure your appliance is installed and plugged into a 120 Volt grounded outlet. • This appliance must be electrically grounded in accordance with the National Electrical Code ANSI/ NFPA No. 70—latest edition in the United States, or CSA C22.1, Part 1 in Canada, and local code requirements. Tools You Will Need 1- Phillips® Screwdriver; 2-Pencil; 3-Ruler or Tape Measure and Straight-edge; 4-Hand Saw or Saber Saw; 5-Level. Warmer Drawer Installation 1. Locate the 2 anti-tip brackets supplied as shown on figure 1. c/c 25 5/16" (64,3 cm) 24" (61 cm) Max. 23 5/8" (60 cm) Min. c/c 12 21/32" (32,1 cm) 2. Slide the drawer into the cutout opening until the front frame of the drawer is flush against the cabinet. Be careful not to pinch the electrical cord. 3. Remove the drawer as instructed in the Use & Care Guide and secure the drawer housing to the cabinet using the 2 black head screws (10-16 X .") supplied (see Figure 2). Do not overtighten screws. 4. The 60" (152,4 cm) appliance power cord can now be connected into the 120 Volt outlet. 5. Proceed with mounting the built-in oven above the drawer (if applicable). Follow the installation instructions provided with the built-in oven. Make sure to use the anti-tip brackets supplied with the built-in oven. supplied to attach drawer to front of Figure 2 Use screws cabinet. Electrical connection IMPORTANT Please read carefully. For personal safety, this appliance must be properly grounded. The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong grounding wall receptacle to minimize the possibility of electric shock hazard from the appliance. The wall receptacle and circuit should be checked by a qualified electrician to make sure the receptacle is properly grounded. Where a standard 2-prong wall receptacle is installed, it is the personal respons...