Оценок - , средний балл:
(
)
)
Производитель: Bloomfield
Размер: 785.4 kb
Название файла: 525dacc6-a15e-4a44-9393-7aeaf0f40b30.pdf
Язык инструкции:
Документ загружается, подождите пожалуйста
 |
Документ загружается, подождите пожалуйста
Фрагмент инструкции
Do not wash floor or counter around this appliance with water or steam jet. Exposed surfaces of appliances can be hot to the touch and may cause burns. Warmer surfaces will be very hot when in use. Contact will cause severe injury. Do not operate any appliance if the control panel is damaged. Do not operate any appliance if the keypad section of an electronic control panel is torn or broken. Call your Bloomfield Agent for service. Protect electric power cords from damage and abrasion. Do not drape an electric power cord over sharp edges or hot objects. Maintain all required clearances. Do not stack or store materials within clearance areas. Do not store flammable or combustible materials near appliances. Any procedure which requires the use of tools must be performed by a qualified technician. Operation manual are considered to be a permanent part of the associated appliance. The manual and all supplied instructions, diagrams, schematics, parts breakdown illustrations, notices and labels must remain with the appliance if it is sold or moved to another location. Bloomfield brewers are made in the USA. Unless otherwise noted, appliances have American sizes on all hardware. WARNING: Electric Shock Hazard All servicing requiring access to non-insulated electrical components must be performed by a factory authorized technician. DO NOT open any access panel which requires the use of tools. CAUTION: Risk of Damage DO NOT connect or energize any appliance until all installation instructions are read and followed. Damage to the appliance will result if installation instructions are not followed. CAUTION: Hot Surface Exposed surfaces can be hot to the touch and may cause burns. 3 OPERATION 4 CAUTION: Hot Surface Exposed surfaces can be hot to the touch and may cause burns. CAUTION: Hot Brew chamber and contents will be hot. BREWING TEA 1. Use a clean brew chamber. Inspect the brew chamber to ensure that it is free from tea leave from the previous brew. 2. Be sure the wire rack is in place in the bottom of the brew chamber. 3. Insert one (1) genuine Bloomfield paper filter in the bottom of the brew chamber. 4. Pour the proper amount of fresh tea leaves into the brew chamber. 5. Gently shake the brew chamber to ensure an even distribution of tea leaves. 6. Slide the brew chamber into place under the brew head. 7. Position an empty dispenser on the base of the brewer. Be sure the brewing cover is properly positioned so that the cold water bypass nozzle is aligned with the slot in the cover. 8. When the "Ready-to-Brew" light glows the brewer is ready to brew tea. Press and release the "Brew Start" switch to begin the brew cycle. 9. The brew cycle is completed when tea is finished dripping from the brew chamber. Remove the brew chamber and discard the used filter and tea leaves. 10. Fresh brewed tea is now ready to serve from the faucet on the dispenser. CLEANING 5 PROCEDURE: Clean Tea Brewer PRECAUTIONS: Disconnect brewer from electric power. Allow brewer to cool. FREQUENCY: Daily TOOLS: Mild Detergent, Clean Soft Cloth or Sponge Bristle Brush. 1. Disconnect brewer from electric power. Allow brewer to cool before cleaning. 2. Remove and empty dispenser. 3. Remove and empty brew chamber. 4. Remove the spray disk from the brew head: Press up on the spray disk ears, then turn the disk to the left to unlatch. Remove the gasket from inside the brew head. 5. Wipe inside of brew head and area around the brew head with a soft clean cloth or sponge moistened with clean water. 6. Wash the spray disk in a sink using warm water and a mild detergent. A bristle brush may be used to clear clogged spray holes. Rinse the spray disk with clean water and allow to air dry. 7. Wash the brew chamber in a sink using warm water and a mild detergent. A bristle brush may be used to clean the inside. Rinse with clean water and allow to air dry. Be sure the wire rack is properly reinstalled. 8. Wipe the exterior of the brewer with a soft clean cloth or sponge moistened with clean water. 10. Reinstall the gasket INSIDE the brew head, then reinstall the spray disk. 11. Reinstall the brew chamber. 12. Clean dispenser interior and brew cover with mild detergent. A bristle brush may be used. Rinse with clean water and allow to air dry. 13. Clean sight glass with a sight glass brush. 14. Disassemble faucet to clean. Rinse and reassemble. Procedure is complete CAUTION: Burn Hazard Brewing and serving temperatures of coffee are extremely hot. Hot coffee will cause serious skin burns. CAUTION: Electric Shock Hazard Do not submerge or immerse brewer in water. IMPORTANT: DO NOT use steel wool, sharp objects, or caustic, abrasive or chlorinated cleansers to clean the brewer. CLEANING 5 PROCEDURE: Clean Tea Brewer PRECAUTIONS: Disconnect brewer from electric power. Allow brewer to cool. FREQUENCY: Daily TOOLS: Mild Detergent, Clean Soft Cloth or Sponge Bristle Brush. 1. Disconnect brewer from electric power. Allow brewer to cool before cleaning. 2. Remove and e...