Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
To retain the safety and performance built into this ice machine, it is important that installation and maintenance be conducted in the manner outlined in this manual. Table of Contents Specifications....................................................................................Page 2 General Information And Installation..............................Page 3 Water Supply And Drain Connections..............................Page 4 Final Check List..................................................................................Page 5 Operating Instructions......................................Page 6 Operational Checks.......................................Page 7 Component Description.....................................Page 8 Operation - Electrical Sequence.................................Page 9 Freeze Cycle......................................................................................Page 10 Cleaning Switch..................................................................................Page 11 Service Diagnosis................................................................................Page 12 Service Diagnosis................................................................................Page 13 Maintenance And Cleaning Instructions.............................Page 14 Cleaning Water System.....................................Page 15 Wiring Diagram..................................................................................Page 17 Warranty ................................................................................Page 18 Page 1 ICEU070A Specifications_ The ice machine must be installed indoors in a controlled environment. Minimum Maximum Air Temp 500F. 950F. Water Temp 400F. 1000F. Water Pressure 20 PSI 80 PSI Voltage 103.5 126.5 Operating the ice machine outside of the above limitations, or outdoors, is potentially damaging to the machine, and it is misuse of the machine. This may void the warranty. Ice-O-Matic ice machines are designed and manufactured with the highest regard for safety and performance. They meet or exceed the standards of agencies like NSF and UL. Ice-O-Matic assumes no liability or responsibility of any kind for products manufactured by Ice-O-Matic that have been altered in any way, including the use of any part and/or other components not specifically approved by Ice-O-Matic. Ice-O-Matic reserves the right to make design changes and/or improvements at any time. Specifications and design are subject to change without notice. UNPACKING AND INSPECTION 1. Call your authorized Ice-O-Matic Distributor or Dealer for proper installation. 2. Remove the front panel of the unit and inspect for any concealed damage. Notify carrier of your claim for the concealed damage. 3. Check that refrigerant lines do not rub against or touch other lines or surfaces, and that the fan blade moves freely. 4. Check that the compressor fits snugly onto all its mounting pads. 5. Remove all internal support packing and masking tape. Model Electrical (volts/Hz/phase) Fuse Size Amps Condenser Type Refrigerant Charge ICEU070A 115/60/1 15 6 Forced Air 9.5 oz R-134a 15 3/16" 1 13/16" tr 11 5/8" Legs adjust to 6" from base. 25 5/8" Door Opening: 12 1/8" wide by 8 1/4" tall 8 1/8" 1 9/16" Cord Set 3 7/16" Drain 3/4" GAS / BSPP Page 2 ICEU070A General Information And Installation This model is supplied from the factory completely pre-wired and requires only electrical power connections to the wire cord provided at rear of the unit. Make sure that the ice machine is connected to its own circuit and individually fused (see data plate for maximum fuse size). This is a cord-connected unit designed for 115 volt AC power, with a maximum fuse size of 15 amps. Low voltage can cause improper operation and may be responsible for serious damage to the overload switch and motor windings that is not covered by warranty. NOTE. All external wiring should conform to national, state and local standards and regulations. Check voltage on the line and the ice maker’s data plate before connecting the unit. Extension cords must not be used. Location: If the unit is built into a cabinet with no side ventilation, the ice production will be reduced by 20% of rated capacity, restricted space of an inch or so on each side will cause a 10% reduction. Six inches of space to the left and right will allow the unit to operate satisfactorily. The daily ice-making capacity is directly related to the condenser air inlet temperature, water temperature, conditions of the condenser air filter and age of the machine. To keep your Ice-O-Matic ice machine at peak performance levels, periodic maintenance checks must be carried out as indicated on the Maintenance and Cleaning section of this manual. Warranty The warranty statement for this product is on page 18 of this manual. Refer to it for applicable coverage. In general warranty covers defects in material or workmanship. It does ...