Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
With this machine refer to the inch version. Note: Some illustrations may be slightly different from your machine. INTRODUCTION INTRODUCTION This manual contains detailed instructions on the operation and care of this machine. To get maximum versatility from this machine, all operators should read and follow the instructions in this manual. Please keep this manual in a handy place near the machine. SAFETY INFORMATION When using your machine, the following safety precautions should always be followed: Safety During Operation In this manual, all safety messages are identified by the words “WARNING” and “Caution”. These words mean the following: A\WARNING:^mPortant information to alert you to a situation that might cause serious injury and damage to your property if instructions are not followed. As Caution-1 mPortant information on how to prevent damage to your equipment, or how to avoid a situation that might cause minor injury. - WARNING - 3 Do not modify or replace any parts other than the ones specified in this manual. ~i Since some parts of the machine are supplied with high voltage, touch only the parts specified in this manual. 3 Do not operate the machine without covers. You might get your fingers caught in the machine, or the machine might be damaged because, for example, dust or the like might get inside it. ~i Since some parts of the machine are sharp and might cause injury, touch only the parts specified in this manual. SAFETY INFORMATION - Caution - □ While printing, do not turn off the main switch. □ While printing, do not open the door or covers. □ While printing, do not unplug the power cord. □ While printing, do not move the machine. □ Keep corrosive liquids, such as acid, off the machine. □ Do not allow paper clips, staples, or other small objects to fall inside the machine. □ Open and close the door and covers softly. □ Do not put anything except originals or command sheets on the machine. □ Do not spill liquid on the machine. □ When opening or closing the door or covers, keep hold of them so they don’t full. □ If you clean rubber parts with benzine, wipe them with a dry cloth afterwards. General Safety Information 3 Always turn the machine off when you have finished printing for the day. □ When the machine will not be used for long periods, disconnect the power cord. □ If the machine must be transported by vehicle, please contact your service representative. Section 1 TABLE OF CONTENTS TABLE OF CONTENTS INTRODUCTION ..............................................................................i SAFETY INFORMATION .................................................................i Safety During Operation.............................................................................i General Safety Information ........................................................................ii GUIDE TO COMPONENTS .............................................................1 Machine Exterior ........................................................................................1 Machine Interior..........................................................................................3 Options .......................................................................................................5 Operation Panel...........................................................................................6 Indicators.....................................................................................................8 INSTALLATION REQUIREMENTS .................................................9 Optimum Environmental Conditions...........................................................9 Environments To Avoid...............................................................................9 Access To The Machine ............................................................................9 Power Connection ......................................................................................10 OPERATION ....................................................................................11 Printing Paper.............................................................................................11 Originals .....................................................................................................12 Preparation For Printing .............................................................................13 Standard Printing........................................................................................17 Restoring Paper Feed And Paper Delivery Tables ...................................19 Adjusting The Image Position ....................................................................21 Adjusting The Image Density .....................................................................23 Changing The Printing Speed ....................................................................24 Stopping The Machine During A Print Run ............................