Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Power Shut-Off This mode saves more power than the Power Save Mode, but requires more time before copying can begin. When the copier enters the power shut-off, the Ready Indicator will flash and the other indicators will turn off. To copy from the power shut-off, press the Start button, then select the desired features and press Start again. Xe88qrg.bk Page 19 Thursday, February 17, 2000 4:25 PM 2.19 User Guide TWO SIDED COPYING 2 Auto Clear This WorkCentre is enabled at the factory to return to the Normal Copy mode approximately one minute after a job is completed. • Copy Quality - Auto • Copy lighter/darker - Normal • Priority Magnification - 100% •Quantity Selected - 1 Adjust the side guide within 1/32 in. Two-Sided Copying Place one original face down on the Document Glass, with the TOP toward the LEFT. Lower the document cover. Select quantity. Press Start to make side 1 copy. Note: 16 lb/60 g/m2 paper is not recommended for two-sided copying. 1 2 3 Note: Failure to follow this procedure will cause paper jams and copy quality defects. Xe88qrg.bk Page 20 Thursday, February 17, 2000 4:25 PM 2.20 User Guide COPYING WHILE PRINTING Remove the first original and place the second original face down on the Document Glass with the TOP toward the RIGHT, and lower the document cover. Remove side 1 copy from the output tray and insert it face down, BOTTOM toward the TOP OF THE PAPER TRAY. Select a quantity of one. Press Start. Copying While Printing To copy a job while the machine is printing: Set up the copy job while the machine is printing. Press Start. The current page will finish printing, then the copy job will start. 4 5 6 7 1 2 Note: When you complete the copy job, the factory preset is 1 minute before it reverts to print mode, or you may touch the On-line/Off-line button to take it back to print mode. The machine will resume printing if pages are pending. Xe88qrg.bk Page 1 Thursday, February 17, 2000 4:25 PM User Guide 3.1 3 Chapter Three Printing From your Windows application file menu, choose Printer Setup (or the equivilant). Select the WorkCentre XE printer. Click OK. Click on the Print Button. 1 2 3 PRINTING Note: For help with Printer Setup, refer to the documentation that came with your Windows software application. Xe88qrg.bk Page 2 Thursday, February 17, 2000 4:25 PM 3.2 User Guide Enabling High Speed Printer Communications To ensure high-speed print performance, the WorkCentre XE88 was designed to take advantage of high-speed parallel port communications between your personal computer and your WorkCentre. This can be accomplished by enabling the Extended Capabilities Port (ECP) mode for your personal computer parallel port (LP1, LPT2 etc.). If your personal computer does not appear to have ECP mode enabled, do the following: Check the documentation for your personal computer for a description of this feature. Look particularly for BIOS and/or CMOS settings. If necessary, call the manufacturer of your personal compu...