Оценок - 4, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
2 Rock the cartridge 5 or 6 times to distribute the toner evenly. NOTE • Always hold the cartridge as shown so that the side with the instructions are facing upward.Do not forcefully move or push the protective shutter of the drum in any way. 3 Place the cartridge on a flat and stable surface, grip the sealing tape tab and snap it in the direction shown below. Make sure that the tab itself is detached from the cartridge. 4 While grasping the cartridge firmly, slowly pull the sealing tape tab with the other hand to remove the sealing tape completely.Discard the tape. IMPORTANT • Be sure to remove the sealing tape completely. Otherwise, toner will not be supplied to the machine and no image or text will be transferred to the page. • To avoid breaking the sealing tape when removing, pull the tab straight out.Do not pull it out at an upward or downward angle. 5 Open the right cover. Right cover Tab Drum protective shutter Instructions Turn over to continue 6 Hold the cartridge and position the arrow mark on the cartridge towards the inside of the machine shown below. 7 Align the projections on both sides of the cartridge to the guides in the machine (location 1) and gently slide the cartridge into the machine until the right cover slightly rises up (location 2). IMPORTANT • The right cover moves simultaneously with the action of the cartridge.Do not push the cartridge farther than the location 2. Doing so will result in catching your hand in the right cover. 8 Close the right cover, and the cartridge will be set in place (location 3). Installing User Software (Windows 98/Me/2000/XP) IMPORTANT •Before you can print, you must install the user software on your computer. Screen shots in the following installation procedures are for Windows 98. 1 Make sure the USB cable is NOT connected to your machine and computer. IMPORTANT •If the Plug and Play is automatically carried out and the Found New Hardware Wizard appears, click Cancel, and follow this procedure. 2 Insert the CD-ROM into your CD-ROM drive. 3 If AutoRun is enabled, the installation starts automatically. NOTE •If installation does not start automatically, choose Run... from the Start Menu,Type D:\Drivers\us_eng\prnsetup\Setup.exe (if your CD-ROM drive is drive D:) in the command line and click OK. 4 Click Next> . 5 When the License Agreement appears, check the contents. Select I accept the terms in the license agreement, then click Next> . NOTE •The message recommending to restart your computer may appear under some operating systems. In this case, continue installing after restarting your computer. 6 Check Install Printer Driver through a USB Connection, then click Next> . When the screen (on the upper right) appears, follow the procedure below 6-1 Be sure to remove the transparent USB label . 6-2 Connect the USB cable to the machine and computer. The program will start installing the Printer Driver automatically. 7 When the following screen appears, select Yes, I want to restart my computer now. Then click Exit. USB interface connection Reading Electronic Manuals To see the guides, proceed as follows. 1 Insert the CD-ROM into your CD-ROM drive. 2 On the Windows desktop, click Start, and then Click Run... 3 In the Run dialog box, type D:\Manuals and click OK ( where D: is the CD-ROM drive containing the installation disk ). The Printer Guide is available in the manuals folder. NOTE •If you do not have Adobe Acrobat Reader installed on your computer, follow the procedure below to install it. 1 Insert the CD-ROM into your CD-R...