Оценок - 2, средний балл: 3
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Set-Up Sheet Unpack the machine and its components. Check that you have the following: IMPORTANT • Save your sales receipt for proof of purchase in case your machine requires warranty service. NOTE • A printer cable is not included.You need a USB cable (less than 16.4ft./5m) to connect your machine to a computer. . Machine . Canon S35 Cartridge . Cassette/Multi-purpose tray . Power Cord . Documentation (Set-Up Sheet, Basic Guide, Registration Card, Limited Warranty Card) . CD-ROM Removing Shipping Materials 1 Place the machine on a flat surface. 2 Remove the shipping tapes on the machine and cassette/multi-purpose tray. NOTE • DO NOT remove the transparent USB label Aat this stage. 3 Open the platen glass cover Bto remove the inner protection sheet C. Installing the Cassette Raise the cassette slightly toward the machine, and align the hooks on both sides of the cassette with the guides in the machine, then insert the cassette into the machine as far as it will go 1. Then gently lower the cassette 2. NOTE • Install the cassette so that there is no space between the cassette and the feeding slot. 1 2 Transparent USB label Left side view Loading Paper in the Cassette 1 Load the paper stack in the cassette. • Insert the paper stack into the cassette as far as it will go. 2 Slide the width guides Aand the length guide Bto fit the size of the paper stack. • Adjust the guides so that there is no space between the guides and the paper. NOTE • Make sure the paper stack does not exceed the width and length guides’ claws. 3 Set the multi-purpose tray on top of the cassette. Connecting the Power Cord When the power cord is plugged into the machine and into the wall outlet, the machine is turned on.There is no separate ON/OFF power switch. Once connected, the machine needs to warm up before you can use it.The LCD displays PLEASE WAIT, then INSTALL CARTRIDGE.The LCD returns to the standby display when you install the cartridge and load paper in the cassette or multi-purpose tray. NOTE • Insert the power cord straight into the power cord connector on the left side of the machine. Do not insert it at an angle.Otherwise, the machine may not be properly connected to the power source and may not turn on. If this happens, disconnect the power cord, and reconnect it correctly after a minute or more. •When disconnecting or connecting the power cord, be sure to unplug or plug the power cord from the wall outlet, not from the power cord connector on the machine. Installing the Cartridge 1 Remove the new cartridge from its protective bag. NOTE • Save the protective bag.You may need it later when you remove the cartridge. 2 Rock the cartridge 5 or 6 times to distribute the toner evenly. NOTE • Always hold the cartridge as shown so that the side with the instructions are facing upward. Do not forcefully move or push the protective shutter of the drum in any way. 3 Place the cartridge on a flat and stable surface, grip the sealing tape tab and snap it in the direction shown below. Make sure that the tab itself is detached from the cartridge. 4 While grasping the cartridge firmly, slowly pull the sealing tape tab straight out with the other hand to remove the sealing tape completely.Discard the tape. IMPORTANT • Be sure to remove the sealing tape completely. Otherwise, toner will not be supplied to the machine and no image or text will be transferred to the page. • To avoid breaking the sealing tape when removi...