Оценок - 2, средний балл: 3.5
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
• BOOTP: The BOOTP server allots the IP address to you automatically. • Static: You can enter IP Address, Subnet Mask, and Gateway manually. EtherTalk This item lets you select whether or not you use the EtherTalk protocol. Select On to use the protocol. NetWare This item lets you select the IPX frame type. • Auto: You can set the printer to select the frame type automatically. • 802.2: Select this value to use the IEEE 802.2 frame type. • 802.3: Select this value to use the IEEE 802.3 frame type. • Ethernet II: Select this value to use the Ethernet 2 frame type. • SNAP: Select this value to use the SNAP frame type. • Off: You can disable the NetWare protocol. Ethernet Speed This item allows you to select the ethernet speed. Wireless Configure the wireless network environments. See 10.4. Note This menu only appears when an optional wireless network interface card has been installed. Clear Setting This item performs a simple reset and restores the factory default settings for the network configuration. This setting will only take effect after you restart the printer. Network Info This item prints a page showing the network parameters you set. Printing a demo page After setting up your printer, print a demo page to make sure that the printer is operating correctly. Press and hold Demo for about 2 seconds. Or, 1 Press Menu and then OK when Information appears. 2 Press the Scroll buttons until Demo Page appears and press OK. 3 Press OK when Yes appears. A demo page prints out. Changing the display language To change the language that is displayed on the control panel, follow these steps: 1 Press Menu until System Setup appears on the bottom line of the display and press OK. 2 Press the Scroll buttons until Language appears and press OK. 3 Press the Scroll buttons to select the language you want and press OK. 4 Press Stop to return to Standby mode. Using toner save mode Toner save mode allows the printer to use less toner on each page. Activating this mode extends the life of your toner cartridge and reduces your cost per page beyond what one would experience in the normal mode, but it reduces print quality. There are two ways to enable this mode: Using the control panel button Press Toner Save on the control panel. The printer must be in Standby mode; the Status LED lights green and Ready is shown on the display. • If the button backlight is on, the mode is enabled and the printer uses less toner to print a page. • If the button backlight is off, the mode is disabled and the printer prints in normal mode. From the software application You can set toner save mode from the printer properties window on your printer driver. See the Software section. 2.6
Принтеры - ML-4050N (7.13 mb)
Принтеры - ML-4050ND (7.13 mb)
Принтеры - ML-4051N (7.13 mb)