|
Инструкция по эксплуатации Safety 1st, модель 44301A
Производитель: Safety 1st Размер: 586.08 kb Название файла: 597_9-25-2006_104233.pdf
|
|
|
|
Перейти к скачиванию
Фрагмент инструкции
(800) 544-1108 Made in USA. Fabrique aux Etats-Unis. Hecho en EE.UU. Styles and colors may vary. Les styles et les couleurs peuvent varier. Los estilos y los colores pueden variar. Distributed by (distribue par) (distribuido por) Dorel Juvenile Group, Inc., 2525 State St., Columbus, IN 47201-7494 Dorel Distribution Canada, 873 Hodge, St. Laurent, QC H4N 2B10 8/30/06 4358-3305C WARNING: PLEASE READ THE FOLLOWING WARNINGS AND ALL ASSEMBLY INSTRUCTIONS CAREFULLY BEFORE USING THE TUBSIDE BATH SEAT. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. PREVENT DROWNING: • Babies can drown in as little as 1 inch of water. ALWAYS bathe your infant using as little water as necessary. • Babies can drown even when other children are in or near the bathtub. DO NOT allow other children to substitute for an adult. • Children have drowned when left unattended in bath seats. ALWAYS keep child within arm’s reach. • NEVER USE BATH SEAT UNLESS IT IS PROPERLY ATTACHED TO A BATH TUB. • Product is suitable for children able to sit up unassisted (approximately 5 months of age). • Product is not suitable for children able to pull up to a standing position who may attempt to climb out (approximately 10 months of age). • Discontinue use if this product becomes damaged, broken or disassembled. Parts Names NOTE: There are no parts to assemble. The names of parts are shown below for your convenience. Adjustable Arm Elbow Cushion Locking Button Clamp Handle Passive Restraint Seat Swivel Seat Locking Tab Bath Seat A A B C B E F G D D F C E G NOTE: The Tubside Bath Seat fits on most standards tubs. DO NOT use on the following style tubs: • The tub edge width is less than 3.5” (8.9 cm) or greater than 5.5” (14 cm) • The inside depth (top to bottom) is less than 12” (30.5 cm) or greater than 15.5” (39.37 cm) • Free Standing (legged or pedestal), Oval or Drop-In • Spa Type Setting Up Your Tubside Bath Seat To Set Up: 1. Slide the Adjustable Arm up, depress Locking Button, and fully extend Arm. 1 Adjustable Arm Locking Button 2. Turn the Adjustable Arm 180 degrees (Figure 2). Slide the Arm down past the Red Warning Label (Figure 2a). 2 2a Red Warning Label Setting Up Your Tubside Bath Seat 3. To place the bath seat onto tub, grasp the Bath Seat and pull the Clamp Handle underneath the Elbow Cushion until fully extended. 4. With Clamp Handle fully extended, fit the Elbow Cushion around the tub edge. Let the Bath Seat slide down to the tub floor. Release the Clamp Handle only when the Bath Seat and Elbow Cushion are fully resting on the tub. CAUTION: DO NOT use the Bath Seat if: • the bottom of Red Warning Label is exposed (Figure 4a). • the Bath Seat and Elbow Cushion are not in full contact with the surfaces of the tub. To Swivel Bath Seat: 3 4 Clamp Handle Elbow Cushion 4a Red Warning Label TIP: Choose your desired seat position before placing your child in the bath seat. 1. To Swivel Seat: Lift Locking Tab on back of seat. Rotate seat away from Elbow Cushion. NOTE: Seat will only swivel 260 degrees. Do not force seat. 2. To Lock Seat: Push down Locking Tab on back of seat. NOTE: Be sure to always lock the seat before placing a child in the Bath Seat. 1 Up to Swivel Down to Lock Using Your Tubside Bath Seat To Use Bath Seat: 1. Fill tub using a minimum of water and check water temperature before putting child in seat. 1 Leg Openings WARNING: Babies can drown in as little as one inch of water. ALWAYS bathe your infant using as little water as necessary. 2. With bath seat attached to the tub, carefully lower your child into the seat. 3. As your child sits down, his or her weight will depress the Passive Restraint Seat which decreases the size of the leg openings for added security. TIP: For baby’s hard to reach spots, you may wish to use the swivel seat option. To Clean: 1. After draining the tub, pull the Clamp Handle towards you, grasp the Seat, and lift the Bath Seat from the tub. 2. Rinse the Bath Seat thoroughly with fresh water. Allow excess water to drain and towel dry. 1 Handle Care of Your Tubside Bath Seat To Store: 1. Slide Adjustable Arm up, depress Locking Button, and fully extend Arm. 1 Locking Button 2. Turn the Adjustable Arm 180 degrees. Slide the Arm down and into the storage position. 2 Storage Position Adjustable Arm Siege de bain avec appui baignoire 44301A Guide d'utilisation Des questions ? Des commentaires ? Contactez-nous : (800) 544-1108 ©2006 Dorel Juvenile Group. All Rights Reserved. (800) 544-1108 Made in USA. Fabrique aux Etats-Unis. Hecho en EE.UU. Styles and colors may vary. Les styles et les couleurs peuvent varier. Los estilos y los colores pueden variar. Distributed by (distribue par) (distribuido por) Dorel Juvenile Group, Inc., 2525 State St., Columbus, IN 47201-7494 Dorel Distribution Canada, 873 Hodge, St. Laurent, QC H4N 2B10 08/30/06 4358-3305C ATTENTION ! LIRE ATTENTIVEMENT LES AVERTISSEMENTS SUIVANTS ET LES INSTRUCTIONS D'ASS...
Напишите ваш отзыв об устройстве
|
|