Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
Because each manual station occupies only one address on the multiplex bus, it can be addressed for any point within the 9 to 255 range allowed by the multiplex expansion module. These manual stations are generally installed near building exits such as stairways and doors, allowing persons evacuating the building to activate the fire alarm. They have optional scored acrylic breakrods and a pull handle that locks in the activated position, to allow easy identification of alarm activation points. These manual stations are high-quality units constructed entirely of non-toxic materials. They have a low profile and rounded edges to fit most design applications. All components are painted or have plated surfaces to inhibit corrosion. Non-corroding screw terminals are provided for wire connections. They are manufactured in conformance with the standards set forth in the Americans with Disabilities Act (ADA). . Easy addressing with rotary switches . Low current draw . Key-lock reset . Replaceable scored acrylic breakrod option . Terminal connections . ADA compliant . UL Listed Functions Alarm Action The single-action FMM-7045 has a white pull-down lever in its center; while the dual-action FMM-7045-D has a white push lever above the white pull-down lever in its center. Pulling down the pull-down lever latches it into place and sends an alarm signal to the control panel over the multiplex bus. The pull-down lever cannot be reset unless the correct key is inserted into the manual station's lock and the unit opened. The latching lever can then be restored to its normal position. Certifications and Approvals Listings and UL UNIU: Boxes, Non-Coded (UL38) Approvals: CSFM: 7150-1615: 122 Complies with: Americans with Disabilities Act (ADA 4.28.3) National Fire Protection Association (NFPA 72) 2 | FMM-7045 Series Multiplex Addressable Manual Stations Installation/Configuration Notes Compatibility Information The FMM-7045 Series Multiplex Manual Stations are compatible with a D7024 FACP with firmware revision 2.0 or greater with a D7039 Multiplex Expansion Module Addressing Addresses are set using three rotary switches. Refer to the D7024 Installation Manual (P/N: 31499 ) and the FMM-7045 Series Multiplex Manual Stations (P/ N: F01U001402) for programming information. Mounting The FMM-7045 manual stations are for indoor use only. The FMM-7045 manual stations flush mount on a standard four-inch square back box with a single-gang mud ring at least 0.625 in. (1.6 cm) deep. For surface mounting, use an FMM-100BB-R Surface.mount Back Box. Wiring The terminal block accepts wiring up to 12 AWG (2.3 mm) in diameter. Refer to the D7039 Installation Instructions (P/N: 38685) for multiplex wiring information. Parts Included Quant. Component 1 Manual station 1 FMM-100GR Scored Acrylic Breakrod 1 D102 Key (1358) 1 Literature pack Technical Specifications Environmental Considerations Radio Frequency No alarm on critical frequencies in the range Interference (RFI) from 26 MHz to 950 MHz at field strengths less Immunity: than 30 V/m. Temperature (Operating): +32°F to +120°F (0°C to +49°C) Mechanical Properties Dimensions (H x W x D) 4.75 in. x 3.75 in. x 3.25 in. (12 cm x 9.5 cm x 8.2 cm) Material Die cast zinc alloy and steel Power Requirements Current Draw (Mux Bus Alarm: 0.55 mA Average): Standby: 0.55 mA Voltage (Operating): 12 VDC nominal (provided by the MUX bus) Ordering Information FMM-7045 Single-Action Manual Station FMM-7045 FMM-7045-D Double-Action Manual Station FMM-7045-D Hardware Accessories D102 Replacement Key D102 FMM-100BB-R Surface-mount Back Box (red) FMM-100BB-R FMM-100GR Scored Acrylic Breakrods FMM-100GR Europe, Middle East, Africa: Americas: Asia-Pacific: Represented by Bosch Security Systems B.V. Bosch Security Systems Bosch Security Systems Pte Ltd P.O. Box 80002 130 Perinton Parkway 38C Jalan Pemimpin 5600 JB Eindhoven, The Netherlands Fairport, New York, 14450, USA Singapore 577180 Phone: +31 40 27 83955 Phone: +1 800 289 0096 Phone: +65 6319 3450 Fax: +31 40 27 86668 Fax: +1 585 223 9180 Fax: +65 6319 3499 emea.securitysystems@bosch.com security.sales@us.bosch.com apr.securitysystems@bosch.com © Bosch Security Systems 2006 | Data subject to change without notice F1930608395 | Cur: en-US, V4, 3 Mar 2006 ...