Оценок - 2, средний балл: 4.5 ( )

Производитель: Ei Electronics Размер: 117.65 kb Название файла: Язык инструкции:

A red light behind the test button or on the cover, will flash while horn is sounding. The alarm will stop when the button is released. Pressing the test button simulates the effect Figure 2 smoke or heat being present (due to insect infestation or contamination build-up for example) the Ei 150, 153 & 155 models can be silenced by disconnecting the mains power. In the case of the Ei 151TL, 154TL & 156TL models (with rechargeable cells) switching off the mains power alone will not silence the alarm as it will still be powered by the cells. Switch off the mains, remove the plug from the rear to disconnect the cells (after removing the Alarm from the ceiling -see figure 1). If cleaning the Smoke Alarm does not correct the problem it can be returned to the manufacturer for repair or replacement. (see below). Hush Feature The Smoke Alarms (Ei 150 & 151TL only) have a Hush Button to help you control nuisance false alarms. 1. To cancel a false alarm, press the Hush Button located on the lower right- hand corner. The Alarm will automatically switch to a reduced sensitivity condition (very large levels of smoke from a nearby fire will override the Hush). This condition allows unwanted alarms to be silenced for a period of approximately 10 minutes. The unit will give a short beep every 40 seconds during this time to let you know the unit has been silenced. On interconnected Smoke Alarms, pressing the Hush Button on the one sensing smoke (i.e. the one with the red light flashing every second) will silence all alarms. Pressing the Hush Button on any other Smoke Alarm will not cancel the alarm. 2. The unit will reset to normal sensitivity at the end of the silenced period. If additional silenced time is required, simply push the Hush Button again. 3. To quickly return to normal non-silenced operation, simply push the Test Button ; the alarm will sound briefly and return to its normal sensitivity alarm mode. 4. After installation, your Smoke Alarm may beep approximately every 40 seconds for 15 minutes. This indicates it is in the Hush mode. To put it into normal operating mode, push and hold the Test Button until the alarm sounds. IMPORTANT SAFEGUARDS When using household protective devices, basic safety precautions should always be followed, including those listed below: • Please read all instructions. • Rehearse emergency escape plans so everyone at home knows what to do in case the alarm sounds. Further information can be obtained from the Home Office Publication entitled “Smoke Detectors in the Home” (FB2) or from your local fire prevention officer. 6 TROUBLESHOOTING ALARM SOUNDS FOR NO APPARENT REASON: (1) Identify the alarm source. On interconnected units the red light under the test button or on the cover will flash rapidly only on the unit which is the source of the alarm. (2) Check for fumes, steam etc. from the kitchen or bathroom. Paint and other fumes can cause nuisance alarms. (3) Fan the unit vigourously with a newspaper to disperse fumes. (4) If alarm does not stop, switch off mains and remove unit (see figure 1). (only remove alarm with red light flashing, the others are probably satisfactory) ALARMS BEEPS CONTINUOUSLY: (1) Alarms may be...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: