Оценок - 4, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
The leaflet should be regarded as part of the product. If you are just installing the unit, the leaflet must be given to the householder. The leaflet is to be given to any subsequent user. INSTRUCTIONS B15583/R0/8/6/06 1:54 PM Page 2 Page CONTENTS 3 WHAT TO DO WHEN THE CO ALARM SOUNDS 4 CARBON MONOXIDE - THE SILENT KILLER! 5 WHERE TO PLACE CARBON MONOXIDE ALARMS 10 INSTALLATION 15 TESTING & MONITORING YOUR CO ALARM 19 MAINTAINANCE 21 LIMITATIONS OF CARBON MONOXIDE ALARMS 22 HOW TO PROTECT YOUR FAMILY 24 TECHNICAL SPECIFICATIONS 26 GETTING YOUR CARBON MONOXIDE ALARMS SERVICED 28 GUARANTEES READ THIS FIRST 28 30 TROUBLESHOOTING 2 B15583/R0/8/6/06 1:54 PM Page 3 1. READ THIS FIRST Power up the unit by smoothly withdrawing the red “pull” tab at the top left hand corner of the unit. If the batteries are supplied separately install the three AA batteries by sliding the upper cover off as shown in figure 5a page 15. The green, red & amber lights will immediately they are working - this is normal. Install the Carbon Monoxide Alarm (CO Alarm) in every room that contains a fuel burning appliance, particularly rooms where people spend a lot of time g. bedrooms, kitchens and sitting rooms. In rooms with an appliance, install (preferably) on the ceiling, (300mm from walls) and between 1m to 3m horizontally from appliance. In rooms remote from the appliance install at breath level, where the light indicators can be seen. Regularly check that the green power light flashes every 45 seconds. If the unit beeps for at least 1 hour when the green light flashes it has reached it’s end of life and must be replaced. (If the ‘Replace by date’ on the side of the unit has not been exceeded replace the batteries if accessible). Test the unit weekly by pressing the test/hush button-the horn will sound. Replace unit after 5 years operation (see ‘Replace by’ date on side wall label). 3 B15583/R0/8/6/06 1:54 PM Page 4 When the CO Alarm detects abnormal levels of CO (above 50ppm CO) the red ? light starts to flash immediately will sound within 90 At higher levels of CO the alarm will turn on sooner (see table B - page 8). The CO Alarm will automatically reset once Pressing the ? test/hush button resets the CO Alarm immediately (below 300ppm CO). If CO is still present the red light and horn will turn on again after about 4 minutes. The CO Alarm is no substitute for keeping chimneys and flues clear and in good condition, and all of your appliances serviced regularly according to the manufacturer’s instructions. Do not fit alarm until all building work is completed to avoid contamination. 2. WHAT TO DO WHEN THE ALARM SOUNDS ? (1) Open the doors and windows to ventilate the area. (2) Turn off all fuel appliances where possible and stop using them. (The alarm can be silenced immediately by pushing the test/hush button). (3) Evacuate the property leaving the doors and windows open. (4) Get medical help immediately for anyone suffering the effects of Carbon Monoxide poisoning (headache, nausea), and advise that Carbon Monoxide poisoning is suspected. 4 B15583/R0/8/6/06 1:54 PM Page 5 (5) Ring your gas or other fuel Keep the number in a prominent (6) Do not re-enter the property until the alarm has stopped. (If the alarm has been silenced by pressing the test/hush button, wait at least 5 minutes so the alarm can check that the CO has cleared). (7) Do not use the fuel appliances again have been checked by an expert. In the case of gas appliances this must be a CORGI registered installer. 3. CARBON MONOXIDE - THE SILENT KILLER! 3.1 What is Carbon Monoxide ? Congratulations on becoming the owner of an Ei Carbon Monoxide Alarm. This will help protect you and your household from the dangerous effects of Carbon Monoxide - the silent killer. (CO is the chemical symbol, indicating the molecule has one atom and one oxygen atom). Many are killed each year, and many more suffer ill health from Carbon Monoxide (CO) poisoning. CO is an invisible, odourless, tasteless and extremely toxic gas. It is produced by appliances and vehicles burning fuels, such as coal, oil, natural/bottled gas, paraffin, wood, petrol, diesel, charcoal etc. CO is absorbed by red blood cells in the lungs in preference to oxygen - this results in rapid damage to the heart and brain from oxygen starvation. 5 B15583/R0/8/6/06 1:54 PM Page 6 High levels of CO in a • Incorrectly or poorly installed fuel-burning appliances. • Blocked or cracked chimneys/flues. • Blocked vents or draught-proofing which makes areas with fuel burning appliances or fireplaces airtight. • Engines of cars, lawnmowers etc. left running in confined spaces. • Portable paraffin or gas heaters in badly ventilated rooms. 3.2 Symptoms of Carbon Monoxide Poisoning Most people know that high levels of CO are harmful, however the period of exposure is also important. The following symptoms are related to Carbon Monoxide poisoning and should be discussed with all members of the household. Mild Exposure: Slight headache, nau...
Эта инструкция также подходит к моделям:Пожарные сигнализации - Carbon Monoxide Alarm Ei 204EN (168.18 kb)
Пожарные сигнализации - Carbon Monoxide Alarm Ei 205CEN (168.18 kb)
Пожарные сигнализации - Carbon Monoxide Alarm Ei 205ENA (168.18 kb)