Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Programme data The programme data (duration, energy and water consumption) can be found in the summary of instructions and refers to standard conditions. Greater deviations may be caused by: different quantities of utensils inlet temperature of the water water pressure ambient temperature mains voltage tolerances and appliance-specific tolerances (e.g. temperature, water flow rate, etc.) The water consumption values refer to water hardness value 2. Switching on the appliance Close the door. Turn on the tap fully. Rotate programme selector 3 to the required programme. Switch on the main switch 1 . The programme sequence display 6 lights up, the programme sequence starts automatically. End of programme The programme ends when the Programme progress indicator 6 has gone out and the End-of-programme indicator 7 illuminates. When the programme ends, the ”Top basket washing” function is de-activated if required (only some models). Several minutes after the programme has ended: Open the appliance door. Wait until the dishes have cooled down and then remove. When the programme has ended, you can either switch off the appliance or restart it with the same or another programme. Switching off the appliance Several minutes after the end of the programme: Switch off the main switch 1 . ”End of programme” display 7 goes out. Turn off the tap (does not apply to Aqua Stop). It is not necessary to adjust the programme selector. Remove the utensils when they have cooled down. At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. en Interrupting the programme Set the main switch 1 to OFF. Indicator lights extinguish. If the hot water was switched ON or the appliance has already heated up and then the appliance door opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may fly open due to expansion. In order to resume the programme, set the main switch to ON again. Terminating the programme (Reset) Only when the main switch is on: Rotate programme selector to the Reset position. The programme sequence lasts approx. 1 min. When the programme has run, switch off the main switch 1 . To restart, rotate the programme selector 3 to the required programme. Switch on the main switch 1 . The programme sequence starts automatically. Changing the programme It is possible to change the programme within 2 minutes after you have switched the dishwasher on. Should it be necessary to change the programme after this period, the programme cycle that has already been begun (e.g. washing) will be completed first of all. Note If the power supply is disconnected while the appliance is operating, e.g. by switching off the appliance or due to a power failure, all settings remain stored. Operation continues automatically as soon as the power supply is restored. Additional functions * * on some models additional functions 4 can be set with the buttons. Pre-Soak * The Pre-Soak programme option serves to perform a pre-soak cycle before the main programme. This cycle enables cookware, e.g. pans, bowls, etc. to be pre-soaked and pre-rinsed in the lower rack. If you wish to pre-soak the dishes, this programme option must be selected by pressing the “Pre-Soak” button before the programme starts. The recommended detergent amount is approx. 5 g poured onto the inside of the door. Time reduction/ time saving * Pressing the “Time reduction/time saving” button provides a short wash cycle by curtailing the drying phase and the washing time. The washing and drying performance will be reduced with the Time reduction/time saving programme o...
Эта инструкция также подходит к моделям:Посудомоечные машины - 4VS352IP/02 (2.38 mb)
Посудомоечные машины - 4VS352IP/04 (2.38 mb)
Посудомоечные машины - 4VS352IP/05 (2.38 mb)
Посудомоечные машины - 4VS352IP/09 (2.38 mb)