Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Add liquid rinse agent to the dispenser as shown until the rinse agent reservoir is full. Wipe up any excess rinse agent that puddles when the dispenser reservoir is full to prevent sudsing. After illing the rinse agent dispenser, the indicator light will go out in a few minutes after the dishwasher door is shut. Setting amount of rinse aid: The amount of rinse aid dispensed can be set from “r:00” to “r:06”. The default factory setting is “r:05”. NOTE: Do not change the amount of rinse-aid unless there are streaks (select lower setting) or water stains (select higher setting) visible on the utensils. ." Press the “POWER” button. ." Press and hold the “A” button and “START” button until the display shows “H:00” ." Release both buttons. The LED for button “A” lashes and the display shows “H:04”. ." Press the “A” button until the display shows “r:05”. To change the setting: ." Press the “C” button until you reach the desired setting. “r:06” is the highest setting and “r:00” deactivates it. ." Press START to save the setting. To turn of the reill rinse aid indicator: ." Follow the instructions described above and set the value to “r:00”. The rinse aid reill indicator is now turned of. 13 DISHWASHER CYCLES AND OPTIONS DISHWASHER CYCLES AND OPTIONS B A C WASH CYCLES CYCLE TIME (mins.) Without options Water Usage Gallons Liters SmartWash™ HE Takes the guesswork out of cycle selection. The sensors in the dishwasher automatically adjust the cycle length, temperature and water changes based on the soil load. This cycle contains additional sensor decisions when compared to other cycles. 105-129 3.5-6.6 13.1-24.9 Pots & Pans * Cleans items having baked-on or hard dried food soils. These items may require soaking or hand scouring. 110-135 4.8-6.3 18.1-23.7 Normal Wash Thoroughly cleans normal loads having loosely attached normal soiling. 95-119 1.5-4.5 5.8-16.9 China Gentle Designed to be used with your fragile china and glassware, allowing you to get it perfectly clean without the hassle of hand washing or worry of damage in the dishwasher. 80-85 2.3-3.7 8..8-13.9 Fast Wash Cleans lightly soiled dishes and reduces overall wash time. Use this cycle to clean glasses and dessert dishes that may need to be re-used at the same event 30 2.7 10.3 Adding options will increase or decrease the cycle time. See “ Cycle Options” information section. * This is a sanitizing cycle. Sanitize Cycle Information A dishwasher cycle that is a sanitizing cycle has been tested to meet very strict performance requirements of wash time and water temperature to ensure dishware and kitchenware sanitization. These performance requirements are explained in the document NSF/ANSI 184, Residential Dishwashers. The sanitizing dishwasher cycles are marked in the chart above with an asterisk. When these cycles are complete, the “Sanitized” indicator on your dishwasher control panel will illuminate. 14 However, if your household water supply is too hot your dishwasher’s heating time may be reduced, and the Sanitized indicator may not illuminate. The cycle times listed in the Use and Care Manual are based on normal soil loads and 120°F incoming water and will vary based on your actual conditions. NOTE: Only sanitizing cycles have been designed to meet the requirements of 6 for soil removal and sanitization ecacy. There is no intention, either directly or indirectly, that all cycles have passed the sanitization performance test. CYCLE OPTIONS OPTION Can be selected with: Added time to cycle Added Water Typical Maximum Gallons Liters Half Load China Gentle reduces 5-10 min reduces 20 min reduces 0.75 reduces 2.5 Normal Wash reduces 5-10 min reduces 40 min reduces 0.3 - 1.2 adds 1.1 - 4.6 Pots & Pans reduces 5-10 min reduces 25 min reduces 0.5 - 1 reduces 1.9 - 3.6 SmartWash™ HE reduces 5-10 min reduces 40 min adds 0.05 - 1 adds 0.2 - 3.5 Dry Assist Improves the drying performance by increasing the time and temperature during the drying stage. With this option you can raise the temperature of the rinse water and increase the drying time for improved drying. Fast Wash adds 11 min adds 11 min None None China Gentle adds 25 min adds 25 min None None Normal Wash * adds 25 min adds 25 min None None Pots & Pans * adds 25 min adds 25 min None None SmartWash™ HE * adds 25 min adds 25 min None None Delay Start You can delay the start of the program in 1-hour steps for up to 24 hours. ." Turn the unit on by pressing the “POWER” button ." Press “+” button until the timer display jumps to “01” . ." Press + or - button until the displayed time corresponds with your requirements. ." Press START button. Delay start is activated. To cancel delay start: ." Press the + or -button until “00” is indicated on the digital display. ." You can change your program selection at any time until the program starts. 15 OPERATING THE DISHWASHER OPERATING THE DISHWASHER Canceling a cycle ." Hold down the “START” button for approximately 3 seconds. The display shows “0:01”. ." The program se...
Эта инструкция также подходит к моделям:Посудомоечные машины - S37KMK25UC/73 (2.71 mb)