Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
They refer to normal conditions and the water hardness set value •:‹…. Different influencing factors such as e.g. water temperature or line pressure may result in deviations. Aqua sensor * * depending on model The Aqua sensor is an optical measuring device (light barrier) which measures the turbidity of the rinsing water. The Aqua sensor is used according to the programme. If the Aqua sensor is active, “clean” rinsing water can be transferred to the next rinse bath and water consumption can be reduced by 3–6 litres. If the turbidity is greater, the water is drained and is replaced with fresh water. In the automatic programmes the temperature and running time can also be adjusted to the degree of soiling. Switching on the appliance – Turn on the tap fully. – Switch on ON/OFF switch (. – Rotate programme selector 8 to the required programme. The expected programme duration flashes on the digital display H. – Press START button @. The programme starts running. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display H. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). en Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. – Close the door. – Switch on ON/OFF switch (. – Press button P until the digital display H jumps to oe:‹‚. – Press button P until the displayed time corresponds with your requirements. – Press START button @, timer programming is activated. – To delete the preselected starting time, press the button P until oe is indicated on the digital display. You can change your programme selection at any time until the programme starts. End of programme The programme has ended when the value ‹:‹‹ is indicated on the numerical display H. Switching off automatically after the end of the programme * * depending on model To save energy, the dishwasher is switched off 1 minute after the programme ends (factory setting). Automatic disconnection can be adjusted from .:‹‹ to .:‹.. .:‹‹ Appliance does not switch off automatically .:‹‚ Off after 1 min .:‹. Off after 120 min – Close the door. – Switch on ON/OFF switch (. – Press and hold down the START button @. – Rotate programme selector 8 until .:‹... s indicated on the digital display H. – Release button. The factory set value .:‹‚ is lit on the digital display H. To change the setting: – Rotate programme selector 8 until the required value is indicated on the digital display H. – Press START button @. The set value is saved. Switching off the appliance Short time after the end of the programme: – Switch off ON/OFF switch (. – Turn off the tap (not applicable if Aqua- Stop fitted). – Remove the utensils when they have cooled down. a=Warning At the end of the programme please open the door fully and not partially when emp...
Эта инструкция также подходит к моделям:Посудомоечные машины - SN25D272EU/09 (3.23 mb)
Посудомоечные машины - SN25D272EU/16 (3.23 mb)
Посудомоечные машины - SN25D272EU/18 (3.23 mb)
Посудомоечные машины - SN25E271EU/01 (3.23 mb)