|
Фрагмент инструкции
Dosage: see manufacturer’s instructions on the detergent packaging. Important Due to the different solvency properties of the detergent tablets supplied by various manufacturers, the cleaning efficiency of the detergent may not be fully utilised by short programmes. It is recommended to use washing powder for these programmes. When you select the “Intensive” programme, tip an extra 10–15 ml of detergent onto the inside surface of the door. Reduce costs! If your dishes are only moderately dirty, you may be able to use less detergent than recommended. Close the lid on the detergent compartment. Press down the lid (1) until it clicks shut (2). If you are using detergent in tablet form, read the manufacturer’s recommendations on the packaging in order to determine where the tablets should be placed inside the dishwasher (e.g. in cutlery basket, detergent compartment, etc.). Make sure that the lid on the detergent compartment is closed, even if you are using tablets. aus Programme overview This overview lists the max. possible number of programmes. The programmes supplied with your appliance are indicated on the fascia. Intensive 70° Drying Drying 115 1,60 21 17 95-145 1,15-1,50 11-19 – Type of crockery e.g.china, pots/pans, cutlery, glasses, etc. Type of food remains Amount of food remains Condition of food remains Wash programme Programme sequence Programme details Duration in minutes with heat exchanger Electricity consumption in kWh with heat exchanger Water consumption in litres with Aquasensor Nondelicate Soups, casseroles, sauces, potatoes, pasta, rice, eggs, roast or fried food a lot very little stuck on hard Eco 50° Quick 35° Pre-rinse Rinse-aid 70° Drying Main rinse Main rinse Rinse-aid 55° Wash 35° Rinse-aid 65° Wash 50° Rinse off if the dishes have been stacked for several days in the dishwasher prior to washing. Pre-rinse Mixed Normal/ Delicate Mixed Normal 45° Rinse-aid 45° Drying a little loosely attached Third rinse Pre-rinse 50° Wash 70° First rinse Second rinse medium The programme sequence isoptimized and adapted with howthe appliance is loaded and howdirty the dishes are. Pre-rinse Main rinse Wash 45° Pre-rinse Soups, potatoes, pasta, rice, eggs, roast or fried food Coffee, cakes, milk, sausage, cold drinks, salads 140 1,05 14 – 120 0,70 14,7 – 30 0,70 10 – 20 0,05 4 – Laboratory measured value in accordance with AS/NZS 2007 Auto 55°/65° aus Washing dishes Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as well as the amount and condition of food remains, with the details contained in the programme overview. The corresponding programme sequence, duration and consumption details are shown in the bottom half of the overview. For example: For a mixture of various types of crockery and utensils with plenty of food remains that are not stuck on fast, use the Auto programme. Reduce costs! If only a small number of dishes have been loaded into the dishwasher, selecting a programme that operates at the next lowest temperature will usually suffice. Programme data The stated programme data are based on standard operating conditions. The values can vary considerably according to: different amounts of dishes temperature of mains water supply pressure of mains water supply ambient temperature fluctuations in mains voltage machine-related factors (e.g. temperature, water volume, ...). Aqua sensor * * some models The Aquasensor is an optical measuring device (light barrier) which measures the turbidity of the rinsing water. The Aqua sensor is used according to the programme. When the Aqua sensor is active, “clean” rinsing water may be transferred into the next rinsing bath and/or the temperature adjusted. If the turbidity is greater, the water is drained and is replaced with fresh water. In this way water consumption can be reduced by approx. 4 litres. Switching the dishwasher ON Turn on the tap. Set main switch 1 to ON. Indicators light up according to the last programme that was selected. This same programme will run again if no other programme button 6 is pressed. The numerical display 3 shows the expected duration of the programme. The programme starts automatically. Programme sequence indicator 7 Your dishes are being cleaned. Your dishes are being rinsed. Your dishes are being dried. Remaining running time display When the appliance has started, the expected programme running time is displayed. The programmed running time is affected by the water temperature, the number of dishes, as well as the degree of soiling. If these conditions are changed, the running time (depending on the selected programme) can vary greatly. aus As the effect is not detected until a programme is running, the time may be longer or shorter than expected. Time delay You can delay the start of the programme in 1-hour steps up to 24 hours. Switch on the appliance. Press the timer programming button 4 until the digital display 3 jumps to . Keep pressing the tim...
Эта инструкция также подходит к моделям:Посудомоечные машины - SGU57M45AU/78 (2.44 mb)