Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
limescale deposits are formed. Any problems which arise as a direct result of the use of these products are not covered by our warranty. aus Programme overview This overview lists the max. possible number of programmes. The programmes supplied with your appliance are indicated on the fascia. Normal 65° Drying Intesive 70° Type of crockery e.g.china, pots/pans, cutlery, glasses, etc. Type of food remains Amount of food remains Condition of food remains Wash programme Programme sequence Programme details Mixed Normal/ Delicate Mixed loosely attached Quick 35° Glass 40° Eco 50° Pre-rinse Wash 65° First rinse Second rinse Rinse-aid 65° Wash 50° Main rinse Rinse-aid 65° Drying Pre-rinse Wash 40° Main rinse Rinse-aid 50° Drying Wash 35° Main rinse Rinse-aid 55° Laboratory measured value in accordance with European Standard EN 50242 Non- delicate Pre-rinse 50° Wash 70° First rinse Second rinse Rinse-aid 70° Drying Soups, casseroles, sauces, potatoes, pasta, rice, eggs, roast or fried food a lot stuck on hard Duration in minutes without heat exchanger Electricity consumption in kWh without heat exchanger Water consumption in litres 106 2,00 23 97 1,70 23 94 1,40 18 87 0,95 19 30 0,80 12 Pre-rinse a little very little Soups, potatoes,pasta, rice, eggs, roast or fried food Coffee, cakes, milk, sausage, cold drinks, salads aus Washing dishes Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as well as the amount and condition of food remains, with the details contained in the programme overview. The corresponding programme sequence, duration and consumption details are shown in the bottom half of the overview. For example: Use the “Normal” programme for dishes and utensils which have plenty of food remains stuck on hard. Reduce costs! If only a small number of dishes have been loaded into the dishwasher, selecting a programme that operates at the next lowest temperature will usually suffice. Programme data The stated programme data are based on standard operating conditions. The values can vary considerably according to: different amounts of dishes temperature of mains water supply pressure of mains water supply ambient temperature fluctuations in mains voltage machine-related factors (e.g. temperature, water volume, ...). Switching the dishwasher ON Set main switch 1 to ON. Indicators light up according to the last programme that was selected. This same programme will run again if no other programme button 5 is pressed. The programme starts automatically. End of programme The programme has come to an end when the PROGRAMME END indicator 3 and the indicator for the selected programme are both lit up. Switching the dishwasher OFF Several minutes after the programme has ended: Set the main switch 1 to OFF. Turn the water tap off. (Does not apply when Aqua-Stop unit has been fitted) Remove dishes, etc. when they have cooled down. Interrupting the programme Set main switch 1 to OFF. Indicator ...
Эта инструкция также подходит к моделям:Посудомоечные машины - SGI43A25AU/43 (2.05 mb)
Посудомоечные машины - SGI43A25AU/49 (2.05 mb)
Посудомоечные машины - SGI43A25AU/56 (2.05 mb)
Посудомоечные машины - SGI43A25AU/70 (2.05 mb)