Оценок - 2, средний балл: 4.5 ( )

Производитель: Kenmore Размер: 834.72 kb Название файла: Язык инструкции:

If you have hard water and use a detergent with a phosphorous content of less than 8.7%, you might need to use more detergent, or use a detergent with a phosphorous content higher than 8.7%. Where to fill Top of 3rd step (3 tbs or 45 g) Top of 2nd step (2 tbs or 30 g) Top of 1st step (1 tb or 15 g) Water Hardness Amount of Detergent Soft to Medium For normally soiled loads: Hard Water • Partially fill the Main Wash 0 to 6 grains per section (2 tbs or 30 g) gallon • Partially fill the Pre-Wash section (2 tbs or 30 g) if needed NOTE: Add only 1 tb or 15 g of detergent to both sections if dishes are pre-rinsed or the water is very soft (0 to 2 grains per gallon). For heavily soiled loads: = Fill the Main Wash section (3 tbs or 45 g) • Partially fill the Pre-Wash section (2 tbs or 30 g) Medium to Hard For normally soiled and Water heavily soiled loads: 7 to 12 grains per • Fill the Main Wash section gallon (3 tbs or 45 g) • Partially fill the Pre-Wash section (2 tbs or 30 g) if needed NOTE: Fillamounts shown are for standard powdered detergent. Amounts may vary if you use liquid or concentrated powdered detergent. Follow instructions on the package when using liquid dishwasher detergent or concentrated powdered detergent. RinseAidDispenser Rinse aids prevent water from forming droplets that can dry as spots or streaks. They also improve drying by allowing water to drain off of the dishes during the final rinse by releasing a small amount of the rinse aid into the rinse water. Your dishwasher is designed to use a liquid rinse aid. Do not use a solid or bar-type. Checking the dispenser Check the center of the Fill Indicator cap, Clear means it needs filling. Or you can remove the Fill Indicator cap. If an "E" is visible, the dispenser is empty. Filling the dispenser The rinse aid dispenser holds 6 oz (175 mL) of rinse aid. Under normal conditions, this will last for about three months. You do not have to wait until the dispenser is empty to refill it. Try to keep it full, but be careful not to overfill it. 1. Make sure the dishwasher door is completely open. 2. Remove the Fill indicator cap. 3. Add rinseaid. Fillto the smallest opening inthe lower part of the dispenser. Overfilling can cause the rinse aid to leak out, and could cause overeudsing. 4. Clean up any spilled rinse aid with a damp cloth. 5. Replace the Fill Indicator cap. Close tightly. DishwasherEfficiencyTips Hot water dissolves and activates the dishwashing detergent. Hot water also dissolves grease on dishes and helps glasses dry spot-free. For best dishwashing results, water must be at least 120°F (49°C) as it enters the dishwasher. Loads may not wash as well if the water temperature is too low. To check water temperature 1. Run hot water at the faucet closest to your dishwasher for at least 1 minute. 2, Place a candy or meat thermometer in a glass measuring cup. 3. Check the temperature on the thermometer as the water is running into the cup. 4, If the water temperature at the faucet is below 120°F (49°C), have a qualified person raise the water heater's thermostat setting. To save water and energy, do not rinse dishes before putting them into the dishwasher. Use a low energy, quick, or short cycle whenever possible. These cycles use less hot water and energy than the Normal cycle. Use a delay feature (on some models) to run your dishwasher during off-peak hours. Local utilities recommend avoiding heavy usage of energy at certain times of day. During the summer, run your dishwasher at night to reduce daytime heat buildup. Use an air dry, or an energy-saving dry option whenever possible. Allow longer drying times (overnight)whenusingthese options.Usearinseaidto improve drying, Use cycles or options that add extra heat to the wash or rinse portion of the cycle only when needed. Run your dishwasher with full loads. Run a rinse cycle after meals until the dishwasher is full. i 13 ControlPanel O OQO gig gOg g SENSING WATER HEATING WASH RINSE DRY CLEAN LOCK ON HOURS 2 46 Ogg g lB _g O qllll) O ANS WASH MISER WASH RINSE I a io0,c.l J :o.si_.1w... SENSINGCYCLES OPTIONS CycleSelectionChart with normal amounts of detergent Select the wash cycle and options desired. Or press food soil. (The energy-dispenser Use this cycle for loads Use both START to use the same cycle and options as the previous usage label is based on sections. cycle. this cycle.) Soft Wash Rinse Main Rinse Final Dry Time Water NOTE: If the last cycle you completed was a rinse cycle, Usa e the dishwasher will run the last full wash cycle and options Level Wash HeatedRinse (mln) Sensed (galkg4|/1. that you selected when you press Start. Heavy • •• •••90* 10.8/ 140°F 140°F 40,9 • If the power is off or the door is open for an extended (sooc) (sooc) period of time, the Start button memory will default to Medium • •••• 86* 8.6/32.7the Normal cycle with heated drying. 140°F 140°F (so'c) (sooc) • If you do not run the dishwasher daily, close the door to Ught • • • • 70* 3.5,'24..= maintain memor...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: