Оценок - 3, средний балл: 5
(
)
)
|
Фрагмент инструкции
D ISHWASHE. For your Safety This manual forms an integral part of the appliance. It must always be kept handy for reference. Read through all the instructions contained in this manual before using the dishwasher. Installation must be performed by a qualified technician, in compliance with the regulations in force, including the prevention and elimination of radio frequency interference. The dishwasher is designed for washing and drying dishes, anyother use shall be considered improper. The manufacturer declinesall responsibility for uses other than those described above. 1. Seperate the various 7. DO NOT install outdoors, not packaging materials and even if the area is covered by dispose of safely - DO NOT a roof: it is extremely leave discarded packaging dangerous to leave it exposed material around the home. to rain and thunderstorms. 2. After removing the packaging, 8. If installed on a carpeted or check to make sure your covered floor, ensure that the appliance is intact. If in doubt, openings on the underside are contact a qualified not obstructed. professional. 9. Do not touch the heating 3. DO NOT use extension leads element during or straight after and multiple plugs. If the a wash cycle. electricity supply wire is not 10. If the appliance malfunctions, long enough, then have it turn off the water inlet tap and replaced with one of the correct disconnect the plug from the length and remember that it wall socket. Then read the should be free of bends or section entitled dangerous kinks. "Troubleshooting". If you 4. In the event of any damage to cannot resolve the problem, the power cord have it then call Hotpoint Service replaced by a qualified (see KEY CONTACTS, back technician. page). 5. The mains plug must be easily accessible after installation. 6. If the appliance is not operating The rating plate, featuring the properly or if maintenance technical data, serial number operations are necessary, and markings, is visibly disconnect the dishwasher positioned on the inner edge of from the mains power supply the door. (unplug it!). DO NOT remove the rating plate. The dishwasher is intended for use by adults. DO NOT allow children to come near or play with the controls. Keep children away from detergents and clear of the dishwasher door when open. Keep all packaging material away from children. 1. DO NOT use solvents, such as alcohol or turpentine which may cause an explosion. 2. DO NOT load dishes to wash that are soiled with ash, wax or paints. 3. DO NOT lean, sit or stand on any part of the dishwasher - this could cause injury and/or damage the appliance. 4. DO NOT drink any water residues from inside the dishwasher. Installation Choose where you want to install your dishwasher, you can place it so that its sides or back panel are side by side with furniture or up against the wall. The dishwasher is provided with water supply and drain hoses, which can be directed towards the left or right to facilitate appropriate installation. Levelling. Once the appliance is positioned, adjust the feet by screwing them in or out depending on how high you want it and to level it so that it is horizontal. Make sure that it is not inclined more than 2 degrees. If the appliance is level, it will help ensure its correct operation. Height Adjustment Insert the appliance into the cutout and then adjust the height using the screws located on the front bottom part of the machine. Use a screwdriver to turn the screws in the clockwise or anti-clockwise direction to increase or decrease the height respectively. Adjusting the Back Feet Insert the appliance into the cutout and then adjust the height using the screws located on the front bottom part of the machine. Use a screwdriver to turn the screws in the clockwise or anti-clockwise direction to increase or decrease the height respectively. Cold water connection. Connect the cold water supply hose to a 3/4 gas threaded connection, taking care to screw it tightly onto the tap. If the water hoses are new or have been out of use for an extended period of time, let the water run to make sure it is clear and free of impurities before making the connection. If this precaution is not taken, the water inlet could get blocked, causing damage to your dishwasher. Anti-flooding protection Your dishwasher has a special system which stops the water supply in the event of leaks inside the appliance. It is equipped with a water inlet that has a clear outer hose and an inner high pressure hose which turns bright red if it breaks. Leaks are prevented as the clear outer hose now contains the water. It is vital that you check it on a regular basis, if you see it has turned bright red, you know you need to replace it as soon as possible. Call for an authorised technical engineer to come and replace it. Drain hose connection. WARNING: Connect your dishwasher drain hose to pipes which connect to the foul drain system and not to surface water drains. IMPORTANT: For the correct operation of your dis...