Оценок - 5, средний балл: 3.6 ( )

Производитель: Mabe Canada Размер: 1.26 mb Название файла: Язык инструкции:

• Select a higher cycle, such as POTS & PANS or HEAVY WASH. Rinse agent dispenser is empty • Check the rinse agent dispenser and fill as required. Dishes and flatware not clean Inlet water temperature • Raise the water heater temperature to 120°F. is below 120°F. • Use HOT START, POTS & PANS or HEAVY WASH and HI TEMP WASH. Too little detergent • See Using the dishwasher section, refer to Proper Use of Detergent for detergent recommendations. Old or damp powdered detergent • See Using the dishwasher section, refer to Proper Use of Detergent for detergent recommendations. Water pressure is temporarily low • Turn on a faucet. Is water coming out more slowly than usual? If so, wait until pressure is normal before using your dishwasher. Air gap is clogged • Clean the air gap. Improper rack loading No air gap or high drain loop • Make sure large dishware does not block detergent dispenser or wash arm. • Verify that you have an air gap or a high drain loop. Refer to the Installation Instructions. Spots and filming on glasses and flatware Extremely hard water Low inlet water temperature Overloading the dishwasher Improper loading Old or damp powder detergent Rinse agent dispenser empty Too little detergent • Use Jet-Dry® or Cascade Crystal Clear® rinse agents to remove spots and prevent new film buildup. • To remove stubborn spots and pre-existing film from glassware: 1 Remove all metal utensils from the dishwasher. 2 Do not add detergent. 3 Select the longest cycle. 4 Start the dishwasher and allow to run for 18 to 22 minutes. Dishwasher will now be in the main wash. 5 Open the door and pour 2 cups (500 ml) of white vinegar into the bottom of the dishwasher. 6 Close the door and allow to complete the cycle. If vinegar rinse doesn’t work: Repeat as above, except use 1/4 cup (60 ml) of citric acid crystals instead of vinegar. Cloudiness on Combination of soft • This is called etching and is permanent. To prevent this from glassware water and too much happening, use less detergent if you have soft water. Wash glassware in detergent the shortest cycle that will get it clean. Water temperature • Lower the water heater temperature. entering the dishwasher exceeds 150°F. Detergent cup lid Dial is not in the OFF • Turn the Timer Dial to OFF. won’t latch position Detergent left in Dishes are blocking the • Reposition the dishes. dispenser cups detergent cups Steam This is normal • Steam comes through the vent by the door latch during drying and when water is being pumped out. Black or gray Aluminum utensils have • Remove marks with a mild, abrasive cleaner. marks on dishes rubbed against dishes Control panel lights Time too long between • Each pad must be touched within 30 seconds of the others. To relight, go off when you are touching or selecting touch any pad again or unlatch and relatch the door. setting controls pads Control panel Door latch may not • Call for service. responded to inputs be properly seated but dishwasher never filled with water 14 GE Dishwasher Warranty Staple your receipt here. Proof of the original purchase date is needed to obtain service under the warranty. All warranty service provided by our Factory Service Centers, or an authorized Customer Care® technician. To schedule service, on-line, 24 hours a day, visit us at ge.com, or call 800.GE.CARES (800.432.2737). Please have serial number and model number available when calling for service. For The Period Of: GE Will Replace: One Year Any part of the dishwasher which fails due to a defect in materials or workmanship. During From the date of the this limited one-year warranty, GE will also provide, free of charge, all labor and in-home service original purchase to replace the defective part. What Is Not Covered: Service trips to your home to teach you how to use the product. Improper installation, delivery or maintenance. Failure of the product if it is abused, misused, or used for other than the intended purpose or used commercially. Replacement of house fuses or resetting of circuit br...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: