Оценок - 5, средний балл: 3.6
(
)
)
|
Фрагмент инструкции
Crockery and cutlery On/Off + ECO 50° 20 g 5 g ** Quick 50° Light soil. Crockery and cutlery On/Off + QUICK 50° 25 g / * Testing programme for EN 50242 (see "Hints for Test Centres"). This programme, developed for the use of detergents with enzymes, allows to achieve, with reduced consumption of energy the same cleaning results that would otherwise be obtained only with the 65°C programmes and conventional detergents. To compensate the lower temperature, the duration of the programme has been prolonged. ** This is a special programme for quick washing a full load of lightly soiled dishes, glasses and crockery (except pots) so that you may re-use them promptly. Cycle description Approximate values * Programme duration in minutes Energy consumption in kWh Water consumption in litres Hot prewash Main wash up to 70°C 2 cold rinses 1 hot rinse Active drying 94 . 104 1,89 18 Warm prewash Main wash up to 65°C 1 cold rinse 1 hot rinse Active drying 79 . 89 1,15 14 Cold prewash Main wash up to 50°C 1 cold rinse 1 hot rinse Active drying 79 . 89 0,99 14 Cold prewash Main wash up to 50°C 1 cold rinse 1 hot rinse Active drying 121 . 131 0,8 14 Main wash up to 50°C 1 cold rinse 1 hot rinse 43 . 53 0,79 11 * The times and consumption values are intended as a guide, and depend on the pressure and temperature of the water and also by the variations of the power supply. Operating instructions 1. Check the filters Ensure they are clean and properly positioned (see "Maintenance and cleaning"). 2. Press the On/off push button The On/Off indicator light will come on. 3. Check that there is rinse aid and salt The corresponding indicator lights will illuminate if refilling is necessary. 4. Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it. Slide the baskets back into the machine. 5. Ensure that the spray arms can rotate freely. 6. Add the detergent Add the required amount of detergent into the dispenser according to the dosage instructions in the "Washing programmes" chart. Close the detergent dispenser lid. 7. Close the dishwasher door 8a. Setting and starting the programme without delay start Press the push button corresponding to the wanted programme: the indicator light corresponding to the programme illuminates and the phase indicator lights for that programme start flashing. The start of the programme will occur after about 6 seconds from the last pressure of a programme push button, in this time it is possible to change programme simply pressing the push button of another programme. Once the programme has started the phase indicator lights will turn off except for the phase under way. It is possible to interrupt the programme: opening the door pressing the On/Off (in this case all the indicator lights turn off) Close the door again o press the On/Off, the programme will start from the point in which it was interrupted. 8b. Setting and starting the programme with delay start The setting of the delay start occurs before selecting the programme. Press the delay start push button and selected the desired time (3, 6 or 9 hours) until the indicator light corresponding to the chosen hours flashes. Press the push button corresponding to the wanted programme: the indicator light corresponding to the programme illuminates and the phase indicator lights for that programme start flashing. The start of the countdown will occur after about 6 seconds from the last pressure of a programme push button. The countdown will decrease with step of 3 hours and you are informed of this by the indicator lights of the hours. During the countdown the only indicator lights illuminate are the programme light and the light of the number of hours to the start of the programme. Once the delayed time has elapsed the programme will start automatically. It is possible to stop a countdown in progress or before it starts, simply pressing the delay start push button until the indicator lights of the hours are off. 9. To cancel a programme in progress A programme in progress can be cancelled at any time. Press for about 3 seconds the push button of the running programme until all indicator lights are off. Only the On/Off indicator light will remain on once the programme has been cancelled. It is now possible to select a new washing programme. 10. At the end of the washing programme The dishwasher will automatically stop and the phase indicator light end of programme will come on. The indicator light of the programme just ended will remain on. The dishwasher has finished the programme only when the phase indicator light end of programme is illuminated. If you do not wait for the end of the programme it will not be possible to start a new programme if first you do not cancel the previous. (For the formalities how to cancel a programme see point 9) Switch off the dishwasher by pressing the On/Off push but...