Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
Preparing Your Dishes for Washing Scrub off all solid food particles from the dishes. > Remove excessive quantities of oil or grease. > Empty any liquids from glasses and cups. > NOTE: Dishes with dried-on foods are more difficult to wash and may not come clean in a normal wash cycle. > Arrange all items with recessed or curved sections on a slant to drain water away. When loading items to be washed: > Load sharp items so that they are not likely to damage the door seal. > Load sharp knives with the handles up to reduce the risk of cut-type injuries > Do not load plastic items unless they are “dishwasher safe”. 6 > Do not load glasses over the dish rack pins. Glasses loaded over dish rack pins are not properly supported and are likely to get damaged. > Items with wooden or bone handles and items joined together with glue are unsuitable as they cannot resist hot water. > Do not touch the heating element during or immediately after use. > Do not operate your dishwasher unless all enclosure panels are properly in place. > Do not tamper with the controls. > Do not abuse, sit on, or stand on the open door or dish-rack of the dishwasher. The machine may topple over. > Protect the cables and hoses from high temperatures. > To reduce the risk of injury, do not allow children to operate or play with the dishwasher. Detergent and Rinse Aid Use How much detergent to use That depends if your water is ‘hard’ or ‘soft’. Generally, hard water requires more detergent to get dishes clean while soft water requires less detergent. The recessed detergent indention located on the inside door panel will hold approximately 12g of detergent. Follow the detergent manufacturer’s guidelines for appropriate detergent quantity. Using a Rinse Aid Use only detergent specifically made for use in dishwashers, as other types can cause over-sudsing. If your detergent is old and/or lumpy, throw it away. Old detergent loses its washing power. Lumpy detergent won’t dissolve. Please put the detergent in the indention on the inner side of the door. You can help prevent unsightly spots on dishes and glassware and reduce drying time by using a rinse aid. A rinse aid is specially formulated to rinse away food and detergent residue that can be left behind on your dishes. Used regularly, a rinse aid will automatically provide you with cleaner dishes every time you wash. Add the rinse aid into this dispenser. The indention for the detergent 7 To fill the rinse aid dispenser, unscrew the dispenser cap located on the inner door (or on the back of the tub, depending on your model). Add the rinse aid slowly into the dispenser until it just reaches the bottom of the filling cap inside the dispenser opening. Then replace the cap. Operating Instructions To operate the dishwasher: Make sure the inlet and drain hoses are correctly and securely connected. 1. Push the door release button to open the door. 2. Check to make sure that the filter (bottom of the machine, above the heating element) is in the right position. 3. Place the dishes on the dish rack and the cutlery inside the cutlery basket. 4. Check to make sure that the rotating spray arm can turn freely all the way around. If necessary, remove any obstacles. 5. Fill the detergent in the recessed area on inner door panel. (12g maximum). 6. Close the door securely 7. Open the water supply. 8. Push the power (on/off) button. o Button pushed in = power on o Button pushed in = power off The LED display and the power light will illuminate indicating the machine is receiving power. 9. Select the desired program by press the program button. The LED will display the washing code you select. The LED will display the default washing mode when it receives power. o P1= Intensive Wash o P2=Normal Wash o P3=Rapid Wash o P4= Eco Wash o P5=Pre-Wash 10. Press the start/pause key to start. The LED will flash the program selected and the washing status during operation. 11. At the end of the cycle the dishwasher will stop running, the LED will stop flashing, and the dishwasher will beep. The LED will turn to black (off) when the machine does not run or operate for 10 minutes or more. The power light will remain illuminated until the power (on/off) button is switched off. 12. The dishwasher is designed to stop if the door is opened accidentally during operation. 8 13. You can select another program during operation by pressing the start/pause key first, then pressing the program key to the desired program, and pressing the pause/start key again to start the new program. 14. After washing, dishes should be allowed to cool down for about 15 minutes so they are not too hot to handle. Dishes will cool more quickly if the door is opened slightly. 15. After unloading the dishwasher, remove the filter, clean off any bits of food, and put the filter back into place. NOTE: At the beginning of each cycle, the dishwasher always starts in the “drain” mode. This is because the drain pump always retains a small amount of water (in the sump...