Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
Connect water inlet hose Ensure that the water inlet hose is not bent or squeezed. Do not install a used hose set. Use a screw-on hose connector to connect the water inlet hose to a water tap with a . inch external thread. If required, use a filter insert to filter deposits from the pipes. Check that the connection does not leak. Important For safety reasons, turn off the tap after every rinse process. 1009 AQUASAFE+ (some models) The Aquasafe+ System protects against water damage hich may be caused at the water inlet hose. Do not immerse the system’s valve box into water; it contains electrical components. In case of damage, pull out the power supply plug. Do not shorten or lengthen the hose insert as it contains electrical cables and components. 1010 ...................................... Water drainage Connecting the drainage hose. Take care to ensure that the drainage hose is not bent or squeezed. Check that the drainage hose is firmly seated. 1011 Extension hoses If a hose extension is required, a drainage hose of equal quality must be used. The maximum length must not exceed 4m. Using a longer hose will produce poorer cleaning results. Siphon connection The drainage height must be between 50 and 100cm above the floor. Use hose clamps to fasten the drainage hose to the siphon. Electrical connection Please refer to the type plate for information on current type, mains voltage, and fuse protection. The type plate is located on the inside of the door. The mains plug must be freely accessible after installation. Power cables and insulated cables must not be accessible (exposed) after installation. Disposal Packaging The packaging and some parts of your appliance are made from recyclable materials. These materials are marked with the recycling symbol and the relevant material type (PE, PS, POM). Before operating your appliance, remove the packaging material and dispose of it in accordance with regulations. .............................................................................................................................. Warning Packaging materials may be dangerous to children.Reusable substances may be dropped off at your local disposal facilities. You may obtain further information from your local authorities and disposal facilities. Used appliances – Environmental notice This product must not be disposed of with your regular household waste. Instead, you need to dispose of the waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment. This is indicated by a symbol to be found on the product, it’s packaging or in the manual. Materials used are recyclable according to their labelling. Reuse, recycling of materials and further reutilization of used products are important contributions to protect our environment. Please ask your local town council for the nearest collection point. To avoid possible dangers, disable your waste appliance prior to discarding it. Pull the mains plug and cut the power cord. Disable any door locks. 4 Using Your Dishwasher Important The electricity and water connections of the dishwater must be in compliance with the instructions in this booklet. Filling the dishwasher salt Important Only use special dishwasher salt in your appliance.The manufacturer is not liable for damage resulting from the use of the wrong type of salt. Do not use coarse-grained salt. Small grains or powdered salt is more easily soluble. Never use culinary or table salt. These types of salt do not dissolve in water easily and will damage the softening device. Remove the lower basket from the appliance. Open the screw-in cap of the salt container by turning it counter clockwise (fig. A,B). When operating for the first time: Pour 1 litre of water into the salt container (Fig. C). Pour the salt into the container with the aid of the salt funnel provided (Fig. D). Pour in enough salt to fill the container. The container holds approx. 2 kg. To speed up the rate of dissolution of salt in water, stir it with a spoon. Close the cap tightly. Begin a washing program immediately after filling the salt container. The washing program prevents damage to the appliance which may be caused by any spilled salt solution. After the first washing cycle, the salt level indicator light will go out. Important Depending on the particle sizes of different salt brands in the market, tablet properties and water hardness, dissolution of the salt in water may take a couple of hours. So, the salt indicator continues lighting for a while after filling salt into the machine. (For models with a salt indicator) 1012 ........ Filling the Rinse Aid Dispenser Rinse aids allow washing water to rinse off more cleanly and prevent watermarks or streaks on the dishes. Only use rinse aid designed for use in dishwashers. Note If you use “2 in 1” or “3 in 1“ detergents / tablets, you do not need an additional rinse aid. Open the rinse aid dispenser by pressing the locking le...
Эта инструкция также подходит к моделям:Посудомоечные машины - D 5001 E (3.96 mb)
Посудомоечные машины - D 5001 ES (3.96 mb)
Посудомоечные машины - D 5001 EX (3.96 mb)