Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
Refer to Figure 2-6. Correct Angle 19376 Incorrect Angle 19377 Bucket Digging Angle Figure 2-5 When loading trucks, curling the bucket close to the dipper stick will prevent undue spillage when the bucket is raised so that it can be dumped in the truck bed. To obtain a level bottom, set the bucket teeth at a slight angle. Keep this angle as you drag the bucket with the dipper stick by gradually uncurling the bucket. Intermittently pull the boom lever at the same time to maintain a level bottom. 19371 Level Bottom Figure 2-6 Land Pride Table of Contents Section 3: Maintenance and Lubrication Maintenance Proper servicing and adjustment can increase the life of any implement. With careful and systematic inspection, you can avoid costly maintenance, time and repair. ! CAUTION! For safety reasons, each maintenance operation must be performed with the backhoe lowered completely to the ground or folded with the transport boom lock engaged and the tractor engine shut off with ignition key removed. • After using the backhoe for several hours, check all bolts to be sure they are tight. • Lubricate items as listed under Lubrication, this section, starting on page 22. • Replace any worn, damaged or illegible safety labels by obtaining new labels from your Land Pride Dealer. Information about labels is located under Safety Labels in the “Important Safety Information” section starting on page 1. Storage For short periods coat all exposed cylinder shafts with grease or a corrosion preventive. Install dust caps on the quick couplers, if equipped, to prevent dirt contamination of the hydraulic system. Or, if possible, connect the quick couplers together. At the end of the working season or when the backhoe will not be used for a long period, it is good practice to clean off any dirt or grease that may have accumulated on the backhoe and any of the moving parts. It may be necessary to scrape off compacted dirt from the bucket, then use a garden hose to thoroughly clean the surface. Inspect the backhoe for loose, damaged or worn parts and adjust or replace if needed. Lubricate as noted in the Lubrication portion of this section starting on page 22. Repaint parts where paint is worn or scratched to prevent rust. Aerosol touch-up paint is available from your Land Pride dealer. Order Land Pride part # 821-002C for Black. Store backhoe in a clean, dry place. Bucket Tooth Replacement To remove a tooth: 1. Heat the tooth with a torch at point “A” (this is the compressed area that overlaps “B”). 2. Hammer at the top of the tooth until the tooth comes free from the shank. To replace a tooth: 1. Hammer the tooth onto the shank. 2. Heat at point “A” and hammer the heated section into recess “B”. B A A 19382 Bucket Tooth Replacement Figure 5-1 7/14/08 BH3512 Backhoes 340-131M 21 22 Section 3: Maintenance and Lubrication BH3512 Backhoes 340-131M 7/14/08 Table of Contents Land Pride Bucket Cylinder Base End Type of Lubrication: Multipurpose Grease Quantity = As required 25 25 Bucket Pivot Type of Lubrication: Multipurpose Grease Quantity = As required 50 Multipurpose spray lube Multipurpose grease lube Multipurpose oil lube Intervals at which lubrication is required Lubrication Legend Lubrication 20555 25 Dipper Stick Pivots Type of Lubrication: Multipurpose Grease Quantity = As required 20556 23 Section 3: Maintenance and Lubrication 7/14/08 BH3512 Backhoes 340-131M Land Pride Table of Contents Boom Pivot Type of Lubrication: Multipurpose Grease Quantity = As required 25 Boom Cylinder Rod End Type of Lubrication: Multipurpose Grease Quantity = As required 25 20557 20555 Boom Cylinder Base End Type of Lubrication: Multipurpose Grease Quantity = As required 25 20556 24 Section 3: Maintenance and Lubrication BH3512 Backhoes 340-131M 7/14/08 Table of Contents Land Pride 20555 Boom Swing Cylinder Base End Type of Lubrication: Multipurpose Grease Quantity = As required 25 25 Stabilizer Arms Type of Lubrication: Multipurpose Grease Quantity = As required Boom Swing Cylinder Rod End Type of Lubrication: Multipurpose Grease Quantity = As required 25 20555 20558 Land Pride Table of Contents Section 4: Specifications & Capacities BH35 Series Backhoes BH3512 Tractor Horse Power Rating 50 -150 Maximum Digging Depth 12’ 6” Digging Depth 2” Flat Bottom 12’ Reach from Swing Pivot 14’ 6” Transport Height 9’ 3” Bucket Clearance or Loading Height 9’ 2” Bucket Curl 172 deg. Swing Arc 180 deg. Stabilizer Spread-Folded Down, Operating Position 10’ 7” Stabilizer Spread-Folded Down, Transport Position 6’ 5” Hydraulic System Four Lever 6-spool control valve Main Circuit Relief 2250 PSI four individual circuit reliefs Hydraulic Fluid Minimum 8.0 GPM Hydraulic Fluid Maximum 11.0 GPM Boom Lifting Power (boom straight out, dipper stick at 90 deg.) 1729 lbs. (less bucket) Boom Lifting Power (boom and dipper stick extended.) 900 lbs. Bucket Cylinder Digging Force 5,500 lbs. Dipper Stick Cylinder Digging Force 3,300 lbs. Bucket Pryout Power (partially curled) 12,500 lb...