Оценок - 1, средний балл: 4
(
)
)
|
Фрагмент инструкции
Install two AA batteries. Remove the packing tape from the tipping funnel. 1 2 3 Press the RESET button. Press the SEARCH button on the main unit to initiate a wireless sensor search. Before proceeding to install the rain gauge outside, please verify communication to the main base station. 5 4 1 3 2 6 8 10 9 4 FOR THE RAIN AND TEMPERATURE STATION 5 7 2 * Find a location for the temperature and humidity sensor Temperature and thermo-humidity sensors should be located in areas protected from the sunlight and rain. Mount the sensor under a covered location like a roof overhang or under the eaves. This will ensure accurate temperature and humidity readings. 1 Find a location for the wireless rain gauge The wireless rain gauge should be placed on a flat and level surface. The location must be away from anything that may block rainfall from entering the rain collector. Rain gauge should be elevated off the ground. Placing your rain gauge on your outside deck would be an ideal location. The distance between the main unit and remote sensor should not be greater than 100 feet. 2 * FAQ’s (Frequently Asked Questions) Problem Applicable Models Solutions "--.-" appears on the temperature display Weather forecast icons is displaying the wrong forecast "--%" appears on the remote humidity display Outdoor temperature reading is wrong. When does the memory reset Weather warning display is blank Atomic Clock is not syncronizing All models BAR208HGA, BAR206A BAR208HGA, BAR206A, RMR203HGA All models BAR208HGA, BAR206A, RMR203HGA, RMR202A BAR208HGA BAR208HGA, BAR206A, RMR203HGA, RMR202A 1) Check main unit or remote sensor battery levels by viewing the appropriate icons on main unit display. 2) Place the main unit away from other electronic devices that might cause signal interference. 3) Decrease the distance between the remote sensor and the main unit The weather forecast feature does not show you current conditions outside, rather it will forecast what the weather will be in the next 12+ hours. Weather forecast is calculated to be 75% accurate NOTE: If you have the RMR203HGA, you need to purchase the THGR268 sensor to display outside humidity. 1) Check main unit or remote sensor battery levels by viewing the appropriate icons on main unit display. 2) Place the main unit away from other electronic devices that might cause signal interference. 3) Decrease the distance between the remote sensor and the main unit Move the remote sensor to a location that will not expose it to direct sunlight or rain. Min/Max memory resets at 12:00 am everyday. The Weather Warnings icons will activate when current weather conditions fall under specific temperature, barometric, or humidity requirements. "Move the main unit close to a window, away from other electronic devices, and hit the up button to intitiate an atomic clock signal search. The best time to achieve successful signal synchronizing is during nighttime hours. It can take up to 24 hours to receive a signal.” 1 ...
Эта инструкция также подходит к моделям:Погодные станции - EMR201A (972.79 kb)